Abstract:The polarization modulator unit for the low-frequency telescope in LiteBIRD employs an achromatic half-wave plate (AHWP). It consists of five layers of a-cut sapphire plate, which are stacked based on a Pancharatnam recipe. In this way, the retardance of the AHWP is a half-wave over a bandwidth of 34-161 GHz. The diameter of a single sapphire plate is about 500 mm and the thickness is 5 mm. When a large diameter AHWP is used for a space mission, it is important for the AHWP to survive launch vibration. A preliminary study indicates that the five-layer stacked HWP has a risk of breakage at the launch unless the five layers are glued together and mechanically treated as one disk. We report our investigation using a sodium silicate solution that can bond the sapphire plates. This technique has been previously investigated as a candidate of cryogenic bonding for a mirror material, including sapphire, of the gravitational wave experiments: LIGO, VIRGO, and KAGRA. We experimentally studied the mechanical strength of the bonded interface for two different surface conditions: polished and unpolished. We demonstrated that the tensile and shear strength > 20 MPa for samples with a polished surface. This satisfied the requirement of 5.5 MPa derived from the mechanical simulation assuming a launch load of 30G. We identified that samples glued on a polished surface exhibit higher strength than unpolished ones by a factor of 2 for tensile and 18 for shear strength. We measured the millimeter-wave transmittance between 90 and 140 GHz using sapphire plates with a diameter of 50 mm before and after bonding. We did not find any optical effects caused by the bonded interface within 2% error in transmittance, which originates from the measurement system.

Scattering in Sapphire Test Masses for Gravitational Wave Detectors

Enabling cryogenic gravitational wave detectors: growth of sapphire crystals with record low absorption in the near infrared

Characterisation of birefringence inhomogeneity of KAGRA sapphire mirrors from transmitted wavefront error measurements

Influence of non-uniformity in sapphire substrates for a gravitational wave telescope

Characterization of birefringence inhomogeneity of KAGRA sapphire mirrors from transmitted wavefront error measurements

Large-mass, low-threshold sapphire detector for rare event searches

Thermally induced depolarization in a silicon (c-Si) single crystal

Simulation of Bulk-Absorption Thermal Lensing in Transmissive Optics of Gravitational Waves Detectors

Precision Mapping of a Silicon Test Mass Birefringence

Material Properties of Popular Radiation Detection Scintillator Crystals for Optical Physics Transport Modelling in Geant4

Investigation into the Anisotropy of Cross-Grinding Surface Quality in C- and M-planes of Sapphire

Comparison of Parametric Instabilities for Different Test Mass Materials in Advanced Gravitational Wave Interferometers

Wide band spectroscopic response of monocrystallines to low dose neutron and gamma radiation

Mechanical strength and millimeter-wave transmittance spectrum of stacked sapphire plates bonded by sodium silicate solution

A hybrid silicon-sapphire cryogenic Fabry-Perot cavity using hydroxide catalysis bonding

Birefringence in a Silicon Beamsplitter at 2um for Future Gravitational Wave Detectors

The Analysis of a Proposed Experiment to Measure the Speed of Gravity in Short Distances

Investigation of Surface Acoustic Waves Anisotropy on High-Quality AlN/Sapphire Grown by Hydride Vapor Phase Epitaxy

Spatiotemporal response of crystals in x-ray Bragg diffraction

A Test of Gravity with Pulsar Timing Arrays

Testing Gravity with Realistic Gravitational Waveforms in Pulsar Timing Arrays