Abstract:Low-cycle fatigue (LCF) behavior of nickel-based precipitation-strengthened superalloy GH4145/SQ was investigated systematically under fully reversed total strain amplitude control conditions at 538°C in laboratory air. It was shown that the alloy exhibited a pronounced initial fatigue hardening followed by continuous fatigue softening to failure at high strain amplitudes, while at low strain amplitudes the initial hardening was followed by a well-defined saturation stage. Microstructure observations using optical and transmission-electron microscopy revealed that slip band density increased with increasing total strain amplitudes and the size of the γ′precipitates tended to reduction due to repeated shearing by the dislocations with continuous cyclic straining. The above changes in microstructures during cycling were essentially responsible for the fatigue hardening–softening behavior of the alloy. Both optical and SEM micrographs indicated that at low strain amplitudes crack propagation was basically transgranular, while at high strain amplitudes crack propagation was essentially intergranular. Bilinear behavior with a change of slope at a plastic strain amplitude of about 0.2pct was observed in cyclic stress–strain (CSS), Coffin–Manson (C–M) and plastic strain energy–life plots. A change in the number of operating slip systems and the fracture modes with the strain amplitude employed was used to explain this two-slope characteristic. In both the companion specimens test (CST) and the incremental step test (IST) methods the alloy exhibited non-masing type behavior. It was suggested that, for the first approximation, the half-life plastic strain energy could be calculated directly according to the equation without reckoning in the non-masing behavior.

High Cycle Fatigue Performance of 6156-T62 Aluminum Alloy

Strain Ratio Effects on Low-Cycle Fatigue Behavior and Deformation Microstructure of 2124-T851 Aluminum Alloy

Low cycle fatigue behavior of nickel-based superalloy GH4145/SQ at elevated temperature

Fatigue Behavior and Microscopic Mechanism of 7020 Aluminum Alloy Profile

Fatigue property of semisolid A357 aluminum alloy under different heat treatment conditions

Anisotropic Low Cycle Behavior of the Extruded 7075 Al Alloy

Test Studies on Fatigue Performance of Aluminum Alloys Used in Construction

Mechanism of Precipitate Microstructure Affecting Fatigue Behavior of 7020 Aluminum Alloy

Rotation Bending High Cycle Fatigue Behaviors of TC21 Alloy with Bimodal Microstructure

Effects of aging temperature on microstructure and high cycle fatigue performance of 7075 aluminum alloy

Microstructural effects on the high-cycle fatigue and fracture behaviors of Ti-6Al-4V alloy

Study on Fatigue Crack Propagation and Extrinsic Toughening of an Al–Li Alloy

Fatigue Crack-Initiation Mechanisms of a Dual-Phase Titanium Alloy Exhibiting High Tensile and High-Cycle Fatigue Properties

Crack Initiation Mechanism in a High-Strength Ti-5Al-7.5V Alloy Subjected to High Cycle Fatigue Loading

On high‐cycle fatigue anisotropy of an aluminum alloy super‐thick plate

Multiaxial Fatigue Behaviour of A356-T6

Ultra-High Cycle Fatigue Behavior of Ti-6al-4v Alloy

Effect of Microstructure on Ultra-High Cycle Fatigue Behavior of Ti–6Al–4V

Comparative Study on the Fatigue Properties and Dislocation Evolution of Three Kinds of Aluminum Alloys

Experimental Investigation and FE Analysis on Constitutive Relationship of High Strength Aluminum Alloy under Cyclic Loading

Fatigue crack growth behavior of 2624-T39 aluminum alloy with different grain sizes