Abstract:Amorphous alumina films are isotropic and have no grain boundaries, which make them have smooth surfaces, excellent properties, and wide applications in protective coatings, catalysis, and microelectronics. However, high-quality alumina films were usually prepared by vapor-phase approaches which need expensive equipment and long production time. Additionally, amorphous films are long-range disordered, which makes the study of structure–property relationships challenging. Here, a simple sol–gel method is employed to obtain high-quality amorphous Al2O3 thin films. The microstructure, morphology, and mechanical properties of amorphous Al2O3 thin films were systematically investigated. All the Al2O3 thin films heat-treated at 600–800∘C are in amorphous state with ultrasmooth surface (Ra values about 0.29–0.43 nm) and high mechanical properties (elastic modulus ∼170[Formula: see text]GPa, hardness ∼20[Formula: see text]GPa). The mechanical properties (E and H) of Al2O3 films gradually increase with the increase of heat-treating temperature. Additionally, the Al coordination of the amorphous alumina films are analyzed by solid-state NMR and correlated with the mechanical properties. The results show that in amorphous alumina, the presence of tetrahedral Al ([4]Al) and octahedral Al ([6]Al) is helpful to improve the mechanical properties, while the five-coordinated Al ([5]Al) is not conducive to improve the mechanical properties. The results demonstrate that sol–gel method is an attractive alternative to time-consuming and expensive vapor-phase approaches and are useful for scale-up to applications and research of amorphous alumina films.

Characterization and Tribological Investigation of Al2O3 and Modified Al2O3 Sol-Gel Films

Research on Surface Modification and Dispersibility of Al_2O_3 in Liquid Wear-Resisting Layer

PREPARATION AND TRIBOLOGICAL PROPERTIES OF TiO2-ZrO2 THIN FILMS

Wear Behaviour and Microstructural Changes of SiCw-Al Composite under Unlubricated Sliding Friction

Characterization and Tribological Behavior of Octadecene, Dodecene and Undecenoic Acid Films on Si Substrate

Friction and Wear Studies of Octadecyltrichlorosilane SAM on Silicon

The Microstructure, Morphology, and Mechanical Properties of Sol-Gel-derived Amorphous Aluminum Oxide Films

Tribological Properties of Sol Gel TiO 2 Thin Fil

Tribological Properties of Al2O3/Graphite-Al2O3 Laminated Composites under Water Lubrication Conditions

Wear-resistance mechanism of an Al–12Si alloy reinforced with aluminosilicate short fibers

Parameter optimization for enhancing tribological properties of sol–gel alumina and aluminum silicate-coated aluminum alloy: Grey–Taguchi method

Wear and Morphologies of the SiOx Film on Aluminum Substrate

Nanotribological Behavior of Ultra-thin Al 2 O 3 Films Prepared by Atomic Layer Deposition

Tribological Characterization of Alumina Ceramic Manufactured by Solvent-Based Slurry Stereolithography

Investigation on growth process and tribological behavior of mixed alkylsilane self-assembled molecular films in aqueous solution

Microstructure, Mechanical and Tribological Properties of CrSiC Coatings Sliding Against SiC and Al2O3 Balls in Water

Wear Properties of NiAl Based Materials

Wear and surface degradation of commercial ZTA femoral heads under boundary lubrication conditions

Atomic Layer Deposition of Zinc Oxide Films: Effects of Nanocrystalline Characteristics on Tribological Performance

Tribological behavior of novel Al2O3-La2O3 HVOF composite coatings

Effect of Heat Treatment on Tribological Properties of SiCp/Al–Mg–Mn–Cu Aluminum Matrix Composites