Replica Multichannel Polymer Chips with a Network of Sacrificial Channels Sealed by Adhesive Printing Method.

F Dang,S Shinohara,O Tabata,Y Yamaoka,M Kurokawa,Y Shinohara,M Ishikawa,Y Baba
DOI: https://doi.org/10.1039/b417398h
IF: 7.517
2005-01-01
Lab on a Chip
Abstract:Replica microchips for capillary array electrophoresis containing 10 separation channels ( 50 mm width, 50 mm depth and 100 mm pitch) and a network of sacrificial channels ( 100 mm width and 50 mm depth) were successfully fabricated on a poly( methyl methacrylate) ( PMMA) substrate by injection molding. The strategy involved development of moving mask deep X-ray lithography to fabricate an array of channels with inclined channel sidewalls. A slight inclination of channel sidewalls, which can not be fabricated by conventional deep X-ray lithography, is highly required to ensure the release of replicated polymer chips from a mold. Moreover, the sealing of molded PMMA multichannel chips with a PMMA cover film was achieved by a novel bonding technique involving adhesive printing and a network of sacrificial channels. An adhesive printing process enables us to precisely control the thickness of an adhesive layer, and a network of sacrificial channels makes it possible to remove air bubbles and an excess adhesive, which are crucial to achieving perfect sealing of replica PMMA chips with well-defined channel and injection structures. A CCD camera equipped with an image intensifier was used to simultaneously monitor electrophoretic separations in ten micro-channels with laser-induced fluorescence detection. High-speed and high-throughput separations of a 100 bp DNA ladder and phi X174 Hae III DNA restriction fragments have been demonstrated using a 10-channel PMMA chip. The current work establishes the feasibility of mass production of PMMA multichannel chips at a cost-effective basis.
What problem does this paper attempt to address?