Abstract:Corrosion of subsurface steel structures is very critical issue especially in moisture subsoil. The use ofphysiochemical properties such as pH, salts concentration, electrical resistivity is very common to quantify corrosivenature of subsoil. However, the laboratory measurements of these parameters are quite difficult due to time and budgetconstraints. In this work soil corrosion potential of a power plant site was evaluated using geophysical and geotechnicalinvestigations. Soil samples were collected from 15 boreholes drilled up-to 50 m depth for laboratory testing whereas 3probes of four electrodes vertical electrical sounding (VES) using Wenner configuration were also performed tomeasure the electrical resistivity of the subsurface soil up to 50 m depth. According to the USCS soil system silty clay(CL-ML) was interpreted as dominant material in all boreholes as shallow depth. Poorly graded sand (SP) including silt(SM) was found of variable depth in almost each borehole. The true resistivity values at the depth of 30 meters liesbetween the 19.9 ohm- meters to 59.8 ohm meters. All observation points of electrical resistivity survey VES-I, VES-IIand VES-III near-surface material show moderate soil corrosion potential which is favorable for design of earthing. Upto depth of 4 m, the values of resistivity 52.6 to 59.8 ohm-meters shows adequate estimation of corrosion. According tothe International standard these curves belong to bell type or K type curve of resistivity model. Their resistivity valueswith respect to depth show low to moderate corrosion potential which is satisfactory for construction at this depth afterapplying the nominal cathodic protections. Thus, electric pipe lines may be installed at this depth.

SOIL FACTORS AFFECTING CORROSION OF GROUNDING GRIDS IN CANGZHOU,HEBEI PROVINCE

Review on Soil Corrosion and Protection of Grounding Grids

Study on the Corrosion Characteristics of Grounding Materials in Acid Red Soil

Research Advances of Soil Corrosion of Grounding Grids

Influence of Current on Soil Corrosion of Galvanized Steel of Grounding Grids

Application of High Density Resistivity Method in Substation Grounding engineering

Research on Corrosion Causes of Common Metal Material in Power Grid

Influence of Air Pollution Factors on Corrosion of Metal Equipment in Transmission and Transformation Power Stations

Investigation on test schemes for grounding grids corrosion diagnosis

Corrosion Mechanism of UHV Transmission Line Tower Foot in Southern China

The Influence and Spatial Variability of Main Mineral Composition of Chinese Loess on Soil Corrosion Resistance

The Theory and Implementation of Corrosion Diagnosis for Grounding System

Novel Method Of Corrosion Diagnosis For Grounding Grid

Integrated Study of Geotechnical and Geophysical Methods to Assess the Soil Corrosion Potential for Construction Site

Analysis on the forest soil acidification status quo in typical acid rain areas of Central and South China.

Grounding resistance measurement analysis of grounding system in vertical-layered soil

Study of the Influence of UHVDC Systems Shared Grounding Electrode on the Environment

Influence of vertical grounding electrodes on electrical characteristics of grounding systems

Distribution and Affecting Factors of Soil Cation Exchange Capacity in Watershed of the Loess Plateau

Seasonal Influences on Safety of Substation Grounding System

Method for Calculating the Galvanic Corrosion Rate of Copper-steel Connected Ground Grids