Abstract:A novel holographic technique for fabricating three-dimensional photonic crystals (PhCs) by two-beam interference is presented in this paper. The optical setup in this method is much simpler and more flexible compared with other multi-beam interference methods, and large and uniform PhCs are easier to be obtained. In PhCs fabrication, two coherent laser beams interfere and generate a set of two-dimensional interference fringes, which are recorded on a plate of photosensitive material. One laser beam is incident on the plate in normal direction and the other beam with an angle to the normal. Then with the laser beams maintained in a fixed relative position, the plate is rotated by 120 degrees about an axis through the center of the plate and a second recording is made. This procedure is repeated one more time, producing finally a superposition of three sets of interference fringes at angles of 120 degree to each other. After the chemical treatment, a three-dimensional PhC is fabricated in the material with a particular lattice structure that depends on the detail of the basic interference pattern. PhC with fcc lattice structure was fabricated in the experiment with the angle of 38.9 degrees between the two interference beams, verifying the effectiveness of the technique.

Fabrication of Two-Dimensional Photonic Crystals with Triangular Rods by Single-Exposure Holographic Lithography

Complicated Three-Dimensional Photonic Crystals Fabricated by Holographic Lithography

Fabrication Of Two-Dimensional Coupled Photonic Crystal Resonator Arrays By Holographic Lithography

Fabrication Of Three-Dimensional Photonic Crystals With Two-Beam Holographic Lithography

Fabrication of 2D Photonic Crystals with Micron to Submicron Hexagonal Lattices Using Single-Exposure Holographic Technique

Photonic Crystal with Diamond-Like Structure Fabricated by Holographic Lithography

Fabrication Of Compound Lattice By Holographic Lithography

Fabrication Of 3d Photonic Crystals With Two-Beam Holographic Technique

Simulated calculation and design for fabricating three-dimensional photonic crystal structures using holographic lithography

Fabrication Of Large-Size Photonic Crystals By Holographic Lithography Using A Lens Array

Fabrication of Large-Area 3D Photonic Crystals Using a Holographic Optical Element

Three-Dimensional Photonic Crystals Fabricated By Visible Light Holographic Lithography

Simulated Calculation and Analysis of the Forbidden Band for Fabricating Two- and Three-Dimensional Photonic Crystal Structures Using Holographic Lithography

Fabrication of Photonic Crystals with Different Surface Orientation by Holographic Lithography

Fabrication and Application of Two-dimension Photonic Crystals

The Fabrication of 3D Photonic Crystals

Fabrication of Photonic Crystals by Holographic Lithography and Mechanism Research on Photonic Crystal Devices

Fabrication Of Holographic Photonic Crystal Template With Back Incident Interference Beams

Fabrication of Photonic Crystals with Tunable Surface Orientation by Holographic Lithography

Fabrication of Photonic Crystals with Functional Defects by One-Step Holographic Lithography.