Abstract:With the raise of resolution, optical payloads are becoming increasingly sensitive to satellite jitter. An approach where the entire spacecraft is pointed with great accuracy requires sophisticated and expensive bus design. In an effort to lower the overall cost of space missions that require highly stable line-of-sight pointing, a method of separating the bus and the payload with low frequency isolators is proposed. This isolation system can block the transmission of disturbance and allow relatively large bus motion. However, if the isolator is linear then there is a trade-off between isolation and static deflection as the launch and the on-orbit stage have difference requirements on the isolation frequency. Otherwise, an extra locking system should be appended to protect the payload before getting into orbit, as the STABLE isolation system[1] and the MIM isolation system[2] did. To overcome this limitation, an alternative approach is to design a nonlinear isolator with high-static stiffness during launch and low dynamic stiffness on orbit. Several specially designed nonlinear isolators have achieved low dynamic stiffness with large static load capacity. Virgin[3] considered a structure made from a highly deformed elastic element to achieve a softening spring. Platus[4] exploited the buckling of beams under axial load in a specific configuration to achieve a negative stiffness in combination with a positive stiffness, and hence low-dynamic stiffness. Others have achieved the same by connecting linear springs with positive stiffness in parallel with elements of negative stiffness[5]~[7]. In the present study, a bifunctional isolator has been developed for optical payloads. The isolator have good performance both during launch and on orbit because of its specially designed nonlinear stiffness and damping. The isolator works in a linear part with low stiffness and small damping ratio under the micro-vibration and microgravity on orbit. The transmissibility requirement and the displacement restriction during launch are satisfied by tuning the nonlinear stiffness and damping parameters. A group of sample isolators are designed tested both statically and dynamically.

Parameter Design and Experimental Study of a Two State Nonlinear Isolator

Parameter design and experimental study of a bifunctional isolator for optical payload protection and stabilization

Modeling and Analysis of a High-Static-low-dynamic Stiffness Vibration Isolator with Experimental Investigation

Comparison of the Dynamic Performance of Nonlinear One and Two Degree-Of-Freedom Vibration Isolators with Quasi-Zero Stiffness

Experiment on Active Vibration Isolation of a Conical Shell Isolator

Simulation And Design Of Composite Vibration Isolator For Spacecrafts

Research on Passive Isolation Characteristics and Rocket-spacecraft Coupling of a New Whole-spacecraft Isolation Platform

Parameter Design of a Multi-Delayed Isolator with Asymmetrical Nonlinearity

Performance of a Launch Isolator: Theoretical and Experimental Study

Study of Piecewise Linear Isolator Mounted on Nonproportional Damped Structures under Liftoff Preload

Measurement for the Dynamic Character of the Whole-Spacecraft Isolator

Passive Control Design of Whole-spacecraft Isolators

Analysis and Experimental Study on Dynamic Characteristics of an Integrated Quasi-Zero Stiffness Isolator

Performance Analysis of the New Whole-Spacecraft Isolator

Active Vibration Suppression of Payloads with a Conical Isolator

DYNAMIC PARAMETER DESIGN OF DISCRETE WHOLE-SPACECRAFT VIBRATION ISOLATION SYSTEM

Design and Experiment of a Three-parameter Isolation System with Optimal Damping

Design and experimental study of a two-stage nonlinear vibration isolators with quasi-zero stiffness

Experimental Analysis on Performance and Damping Reliability of Whole-Spacecraft Vibration Isolators

Experiment of an Isolator Fabricated with Diaphragm Bellows and Viscous Fluid

Optimization Design of the Whole-Spacecraft Isolation System