Abstract:With the raise of resolution, optical payloads are becoming increasingly sensitive to satellite jitter. An approach where the entire spacecraft is pointed with great accuracy requires sophisticated and expensive bus design. In an effort to lower the overall cost of space missions that require highly stable line-of-sight pointing, a method of separating the bus and the payload with low frequency isolators is proposed. This isolation system can block the transmission of disturbance and allow relatively large bus motion. However, if the isolator is linear then there is a trade-off between isolation and static deflection as the launch and the on-orbit stage have difference requirements on the isolation frequency. Otherwise, an extra locking system should be appended to protect the payload before getting into orbit, as the STABLE isolation system[1] and the MIM isolation system[2] did. To overcome this limitation, an alternative approach is to design a nonlinear isolator with high-static stiffness during launch and low dynamic stiffness on orbit. Several specially designed nonlinear isolators have achieved low dynamic stiffness with large static load capacity. Virgin[3] considered a structure made from a highly deformed elastic element to achieve a softening spring. Platus[4] exploited the buckling of beams under axial load in a specific configuration to achieve a negative stiffness in combination with a positive stiffness, and hence low-dynamic stiffness. Others have achieved the same by connecting linear springs with positive stiffness in parallel with elements of negative stiffness[5]~[7]. In the present study, a bifunctional isolator has been developed for optical payloads. The isolator have good performance both during launch and on orbit because of its specially designed nonlinear stiffness and damping. The isolator works in a linear part with low stiffness and small damping ratio under the micro-vibration and microgravity on orbit. The transmissibility requirement and the displacement restriction during launch are satisfied by tuning the nonlinear stiffness and damping parameters. A group of sample isolators are designed tested both statically and dynamically.

Experimental Demonstration of 1.5hz Passive Isolation System for Precision Optical Payloads

Experimental Demonstration of a Low Frequency Isolation System for High Resolution Optical Payload

Design and experiment of dual micro-vibration isolation system for optical satellite flywheel

Vibration Detection and Calibration Method Used to Remote Sensing Optical Camera

Study on Micro-vibration Isolation System Design and Validation for the SDLT-1 Satellite of China

Parameter design and experimental study of a bifunctional isolator for optical payload protection and stabilization

Effect of satellite micro-vibration on imaging quality for optic payload

Micro-vibration control of spaceborne payload with smart parallel struts

Simulation And Design Of Composite Vibration Isolator For Spacecrafts

Design and Experimental Study of a Hybrid Micro-Vibration Isolation System Based on a Strain Sensor for High-Precision Space Payloads

Experimental modeling and optimization of single-gimbal CMG vibration isolator

Novel coarse and fine stage parallel vibration isolation pointing platform for space optics payload

Advances in spacecraft micro-vibration suppression methods

Study of Whole-Satellite Active Vibration Isolation Platform

A Multiple Functional Connector for High-Resolution Optical Satellites

Experiments on Active Precision Isolation with A Smart Conical Adapter

Active Low-frequency Vertical Vibration Isolation System for Precision Measurements

Decoupling design and control of a spaceborne ultra–stable platform for vibration isolation and precise steering

Active Vibration Suppression of Payloads with a Conical Isolator

Design of a Maglev Stewart Platform for the Microgravity Vibration Isolation

Compact Vibration Isolation and Suspension for Australian International Gravitational Observatory: Performance in a 72 M Fabry Perot Cavity.