Abstract:The famous thermal response factor g-function proposed by Eskilson has been widely used for thermal behavior analysis of borehole heat exchangers (BHEs). However, the necessary prerequisite to g-function is the assumption of uniform borehole wall temperature, which has not been comprehensively clarified in literatures yet. Unlike the g-function type solutions, a novel three-dimensional (3D) semi-analytical solution is developed for thermal behavior analysis of single U-tube BHEs without pre-imposing borehole wall condition. Instead, the new solution can provide vertical temperature and heat flux profiles along borehole wall. Studies indicate that a new dimensionless parameter of heat carrying capacity (HCC) can be defined to quantify the relative capacity of convective heat transfer of fluid flow in tube to heat conduction in soil. It is shown that thermal capacity of the single U-tube BHEs can be efficiently improved by increasing heat carrying capacity of low HCCs, and the BHEs with high HCCs (>1.692) exhibit the same thermal behavior as the infinite HCC BHE. Effects of HCC on borehole wall conditions are also examined with the semi-analytical solution. It is revealed that the variation along the borehole wall becomes smaller with increasing HCCs. For the two assumptions commonly used in literatures, the uniform borehole wall temperature assumption can be adopted when HCCs are high, while the uniform borehole wall flux assumption is unreasonable and should be used cautiously. Further study suggests that the g-function solution can be used to formulate an approximate solution for the average fluid temperature when HCC is higher than 0.458, by which the computation cost can be reduced effectively.

Analysis of Ground Thermal Properties Determination Applying Thermal Response Test under Condition of Constant Heating Flux

Numerical Simulation and Analysis on the Heat Transfer of the Vertical Ground Heat Exchanger in Hydrous Soil

Analysis of Influencing Factors on Thermal Response Test in Ground Source Heat Pump

Numerical and Experimental Evaluation on Methods for Parameter Identification of Thermal Response Tests

Preliminary Analysis of the Methods for Ground Thermal Properties Calculations Based on Line Heat Source Model Combined with Parameter Estimation

Comparison of Four Methods for Borehole Heat Exchanger Sizing Subject to Thermal Response Test Parameter Estimation

Sequential estimation of borehole resistance and ground thermal properties through thermal response test

Method for Determining Deep Ground Thermal Properties Accounting for Water Advection

Estimation of Ground Thermal Properties for Coaxial BHE Through Distributed Thermal Response Test

Evaluation on field test methods of ground thermal properties for ground-source heat pump systems

A numerical investigation to analyze the effect of changing ambient conditions on accurate and stable identification of thermal conductivity of ground source heat pump system using thermal response test

Analysis of Influencing Factors on Soil Thermal Conductivity Test in Ground Source Heat Pump

Sensitivity Study of Thermal Response Test Using Resistively Heated Methods under Various Setups

Research And Development Of Thermal Properties Test Device Of Deep Ground Soil For Ground Source Heat Pump

LINE SOURCE METHOD FOR MEASURING THERMAL PROERTIES OF DEEP GROUND

Field Test and Numerical Simulation on Heat Transfer Performance of Coaxial Borehole Heat Exchanger

Estimation of Soil and Grout Thermal Properties for Ground-Coupled Heat Pump Systems: Development and Application

A Novel Semi-Analytical Solution for Thermal Response Analysis of Single U-Tube Borehole Heat Exchangers (Bhes)

Probe Body and Thermal Contact Conductivity Affect Error of Heat Pulse Method Based on Infinite Line Source Approximation

Parameters Optimization of Borehole and Internal Thermal Resistance for Single U-tube Ground Heat Exchangers Using Taguchi Method

Uncertainty Study and Sensitivity Analysis of Soil-Rock Thermal Response Test