Abstract:Deep borehole heat exchanger (DBHE) is attracting attention intensively owing to much more geothermal extraction, higher efficiency for heat pumps, and lesser land demand compared with shallow borehole heat exchanger. DBHE is usually dipped into several thousand meters in the subsurface, having a complicated heat transfer with surrounding rock–soil. However, the heat transfer characteristics below surface under different conditions are rarely studied. In this study, a numerical model considering the comprehensive effects of geothermal gradients and heat loss from inner pipe was proposed. The model was validated with experimental data and Beier analytical solution. Based on the model, the effects of primary design parameters on the heat transfer performance below surface along the pipe were investigated. The results indicate that temperature at pipe bottom increases with inlet flow rate decreasing, while the heat load cannot be extracted fully to the surface because of the heat loss of inner pipe. When the inlet flow rates decrease from 41.39 to 4.52 m3/h, the heat loss ratio increases from 25.5% to 63.7%. It is an effective way of insulating inner pipe to reduce heat loss under low inlet flow rates. Increasing the velocity in inner pipe by lessening the inner pipe diameter can also decline the heat loss well. While by this way, the increasing pumping power resulting from the higher velocity in inner pipe has to be considered. This study is significant to effective optimization of DBHE and energy conservation of buildings. A new deep borehole heat exchanger (DBHE) numerical model with logarithmic discretization in radial direction was proposed, which can account the small distances between the DBHE and the surrounding rock–soil. The developed model considers the comprehensive effects of geothermal gradients and heat loss from inner pipe. The heat transfer along the pipe can be reflected by the temperature profiles and the specific heat load distributions, which is solved on the basis of the finite volume method.

Comparison of Four Methods for Borehole Heat Exchanger Sizing Subject to Thermal Response Test Parameter Estimation

Multi-factor Optimization of Thermo-Economic Performance of Coaxial Borehole Heat Exchanger Geothermal System Based on Levelized Cost of Energy Analysis

Modifications to the Conventional Design Methods for Borehole Heat Exchangers Based on a Novel Response Factor Model

Parameters Optimization of Borehole and Internal Thermal Resistance for Single U-tube Ground Heat Exchangers Using Taguchi Method

Estimation of Ground Thermal Properties for Coaxial BHE Through Distributed Thermal Response Test

A simplified approach to predicting the Heat Extraction Rate of Borehole Heat Exchangers from parametric analysis

Numerical study on the effects of design parameters on the heat transfer performance of coaxial deep borehole heat exchanger

Sequential estimation of borehole resistance and ground thermal properties through thermal response test

Analysis of Influencing Factors on Thermal Response Test in Ground Source Heat Pump

Prediction and Parametric Analysis of 3D Borehole and Total Internal Thermal Resistance of Single U-tube Borehole Heat Exchanger for Ground Source Heat Pumps

Numerical study on the heat performance of enhanced coaxial borehole heat exchanger and double U borehole heat exchanger

Field Test and Numerical Simulation on Heat Transfer Performance of Coaxial Borehole Heat Exchanger

A revised sizing method for borehole heat exchangers in the Chinese national standard based on reliability and economy

Comparison and integration of simulation models for horizontal connection pipes in geothermal bore fields

Performance Evaluation Of Borehole Heat Exchanger In Multilayered Subsurface

Ground Heat Exchanger Design Subject to Uncertainties Arising from Thermal Response Test Parameter Estimation

A TRNSYS-Based Thermal Response Test Parameter Estimation Method

Preliminary Analysis of the Methods for Ground Thermal Properties Calculations Based on Line Heat Source Model Combined with Parameter Estimation

Investigation of the Heat Transfer Performance of Multi-Borehole Double-Pipe Heat Exchangers in Medium-Shallow Strata

A Fast Distributed Parameter Model of Ground Heat Exchanger Based on Response Factor

A New Heat Transfer Model for Single U-pipe Ground Heat Exchanger