Abstract:Geothermal energy exhibits considerable development potential in space heating. Shallow geothermal energy stored in the soil in the form of low-grade energy is mainly extracted via the ground source heat pump (GSHP) system. GSHP systems use the subsoil as a heat source, typically involving a vertical borehole heat exchanger (BHE) to extract heat from the formation. Accurate measurement of the thermal properties of the formation is very important for the design of BHEs. At present, the most common and effective method to measure the thermal conductivity of the formation in the field is the thermal response test (TRT). However, the test conditions (heat load, test time) during the thermal response test can impact the test results. Therefore, in this study, a borehole with a depth of 130 m was evaluated in the field. The TRT module and the distributed thermal response test (DTRT) module based on distributed optical fiber temperature sensor (DOFTS) technology were used to monitor the test with different working conditions in real-time. In the field tests, geothermal conditions and the evolution of the formation temperature with time and depth were determined. Based on the test results under different heat loads and test times, the influence of the test conditions on the thermal conductivity results was analyzed and described. A constant temperature zone was located at a depth from 25m to 50 m, and an increasing temperature zone was located at a depth from 50m to 130 m, with a geothermal gradient of 3 °C/100 m. The results showed that the heat load slightly influenced the thermal conductivity test results. At the initial stage of the test, the temperature significantly increased from 0 to 12 h. After reaching the quasi-stable state, the test time slightly influenced the thermal conductivity test results. The characteristics of the formation thermal recovery stage after the test stage were studied. The heat load decreased, which could shorten the time for the formation to recover the initial temperature. The results could provide a basis for the optimization of thermal response test conditions.

Sequential estimation of borehole resistance and ground thermal properties through thermal response test

Estimation of Ground Thermal Properties for Coaxial BHE Through Distributed Thermal Response Test

Analysis of Influencing Factors on Thermal Response Test in Ground Source Heat Pump

A numerical investigation to analyze the effect of changing ambient conditions on accurate and stable identification of thermal conductivity of ground source heat pump system using thermal response test

Comparison of Four Methods for Borehole Heat Exchanger Sizing Subject to Thermal Response Test Parameter Estimation

A Case Study of Field Thermal Response Test and Laboratory Test Based on Distributed Optical Fiber Temperature Sensor

Estimation of Soil and Grout Thermal Properties for Ground-Coupled Heat Pump Systems: Development and Application

Analysis of Influencing Factors on Soil Thermal Conductivity Test in Ground Source Heat Pump

Evaluation on field test methods of ground thermal properties for ground-source heat pump systems

A TRNSYS-Based Thermal Response Test Parameter Estimation Method

Field Test and Numerical Simulation on Heat Transfer Performance of Coaxial Borehole Heat Exchanger

Research And Development Of Thermal Properties Test Device Of Deep Ground Soil For Ground Source Heat Pump

Preliminary Analysis of the Methods for Ground Thermal Properties Calculations Based on Line Heat Source Model Combined with Parameter Estimation

A New Method to Determine the Thermal Properties of Soil for Vertical-Borehole Ground-Source Heat Pump Systems

Effect of environmental thermal disturbance on effective thermal conductivity of ground source heat pump system

Sensitivity Study of Thermal Response Test Using Resistively Heated Methods under Various Setups

Optimization of the thermal response test under voltage fluctuations based on the infinite line source model

Estimation Method for Layered Ground Thermal Conductivity Using Genetic Algorithm Based on a 2-D Heat Transfer Model

Ground Heat Exchanger Design Subject to Uncertainties Arising from Thermal Response Test Parameter Estimation

Influence of Different Heat Loads and Durations on the Field Thermal Response Test

Estimation of geological formation thermal conductivity by using stochastic approximation method based on well-log temperature data