Abstract:This paper presents the development of a hybrid model for simulating a vertical U-tube geothermal heat exchanger under actual climate.The model consists of a 3D model representing a pair of U-tubes buried in symmetric boreholes and a supplementary 2D model that can be applied to real site scenarios.The temperature series at the wall of the borehole and initial soil temperatures at different depths derived from the simulation results of the 3D model serve as the input boundary conditions of the 2D model.Hence,the hybrid model shares the respective advantages of both subordinate models and therefore provides comprehensive simulation resuhs that span approximately 10 months at a slight cost in implementation complexity.Meanwhile,the model is limited by numerous assumptions such as the consistency between the ground surface and air temperatures and physical uniformity of the materials.Simulations were performed based on the conditions obtained at a real site in the city of Hangzhou.The simulation time range was June 12,2015,to March 17,2016,which covered an entire cooling,transition,and heating season.The collected data revealed that the soil within an effective radius of 2 m gained an absolute increase in internal energy of 0.292 MJ after the simulation.The relative increases in the internal energy and average temperature were 1.037 MJ and 0.28 K,respectively,compared to those affected only by climate,which indicated an unwanted accumulation of heat beneath the ground.Moreover,the temperature at a deeper soil depth showed a lag in phase behind that of a shallower depth.This lag was approximately 2 weeks between a point at the center of the entrance and exit of the U-tubes and a point 1 m below it.Moreover,the fluctuation patterns of the inlet/outlet fluid temperatures showed a significant shift from the air temperature toward the annual averages,which were-8.313 K in the cooling season and 9.077 K in the heating season.Finally,the temperature distribution among pipe-clusters at different depths showed that the heat accumulation mainly occurred at a depth greater than 7 m,and the accumulation was more severe at a shallower depth and at the corners of clusters.

A Fast Distributed Parameter Model of Ground Heat Exchanger Based on Response Factor

Fast and accurate calculation of the soil temperature distribution around ground heat exchanger based on a Response Factor model

A General Distributed Parameter Model for Ground Heat Exchangers with Arbitrary Shape and Type of Heat Sources

Numerical Simulation and Analysis on the Heat Transfer of the Vertical Ground Heat Exchanger in Hydrous Soil

Fast segregation of thermal response functions in short-term for vertical ground heat exchangers

A fast numerical approach for the horizontal ground heat exchanger

Modifications to the Conventional Design Methods for Borehole Heat Exchangers Based on a Novel Response Factor Model

A Simulation Model for Coupled Heat Transfer and Moisture Transport under the Action of Heat Source in Unsaturated Soils

A Simplified Numerical Model as a Design Tool for Vertical Single U-Tube Ground Heat Exchangers

A Simplified Semi-Numerical Model to Simulate a U-pipe Ground Heat Exchanger

A New Constant Heat Flux Model for Vertical U-tube Ground Heat Exchangers

Study on thermal radius and capacity of multiple deep borehole heat exchangers: Analytical solution, algorithm and application based on Response Factor Matrix method (RFM)

Transient Simulation and Performance Analysis for Deep Borehole Heat Exchanger Coupled Ground Source Heat Pump System

Research of Heat and Moisture Transfer Influence on the Characteristics of the Ground Heat Pump Exchangers in Unsaturated Soil

Estimation of Soil and Grout Thermal Properties for Ground-Coupled Heat Pump Systems: Development and Application

A New Heat Transfer Model for Single U-pipe Ground Heat Exchanger

A Study on the Performance of A Geothermal Heat Exchanger under Coupled Heat Conduction and Groundwater Advection

Analysis of Influencing Factors on Thermal Response Test in Ground Source Heat Pump

Hybrid 3D and 2D Numerical Models of Geothermal Heat Exchanger for Ground Source Heat Pump System

Numerical simulation of soil temperature field surrounding vertical U tube heat exchanger for ground coupled heat pump

Finite element modeling of geothermal source of heat pump in long-term operation