Abstract:The forming quality of profiled ring rolling not only encompasses macroscopic accuracy but also emphasizes the microstructure. Due to the multiple process parameters and complex metal flow during profiled ring rolling, the various forming defects are difficult to control and difficult to study theoretically. The objective of this study is to establish a comprehensive method for evaluating the forming quality of profiled rings, which considers both the macroscopic forming accuracy and the microstructure. Firstly, the synthetic size factor was defined, and the evolutionary relation between the section forming rate and the diameter growth rate of E-section ring rolling was analyzed in detail. The synthetic size factor can be used to describe the dimensional evolution and evaluate the forming accuracy of the profiled ring rolling process. Taking into full consideration the features of intermittent deformation in local areas, a microstructure evolution model of the Inconel718 alloy during E-section ring rolling, which can accurately predict the recrystallization volume fraction and average grain size of the final ring, was established. Then, combined with finite element simulation, the influence of the rotation speed of the driving roll on the macro-size evolution and microstructure was systematically analyzed. The results indicate that there is often a discrepancy between dimensional accuracy and microstructure uniformity in the optimization trend. For instance, the higher the rotation speed of the driving roll is, the more uniform the microstructure is, but the more difficult it is for the section profile to form. Finally, combined with response surface methodology (RSM), multi-parameter optimization was carried out with section forming accuracy and grain uniformity as the optimization objectives. By using the optimal parameters, an E-section ring with a complete profile and a uniform microstructure was obtained, with a maximum prediction error of the recrystallization volume fraction lower than 5%. The results show that the macroscopic and microscopic quality evaluation methods proposed in this study, as well as the optimization method combining RSM, can be effectively applied to the process optimization of profiled ring rolling.

Parallel Simulation of Cold Ring Rolling Process

Progress and Prospects of FE Simulation of Two-roll Cross Piercing Process

Numerical simulation of cold longitudinal asymmetric rolling process

Tri-dimensional Elastic-Plastic Fem of Rolling Force During Strip Finishing Rolling Process

Numerical simulation and experimental study on geometry variations and process control method of vertical hot ring rolling

Numerical Simulation Research on Mandrel reaming of Ring Steel Ingot

High precision modeling of welding and post welding cold rolling continuous process in numerical simulation

Three-dimensional rigid–plastic finite element simulation for the two-roll cross-wedge rolling process

Effect of stiffness on non-guide-roll radial ring rolling system

NONLINEAR THREE-DIMENSIONAL SIMULATION FOR HOT CONTINUOUS ROLLING OF STRIP STEEL

FINITE ELEMENT ANALYSIS OF STEADY STATE HV ROLLING PROCESS OF SLAB

Rolling Process Analysis of Working Rollers of Cold Rolling Mill Based on ANSYS

Numerical Simulation of Cast-rolling Process for Copper-Aluminum Composite Plate

The Design and Simulation of Roller for Machining Involute Spline

Multi-objective optimization of parametric design for profile ring rolling process based on residual stress control

An innovative spinning-rolling process and its intelligent FE modelling for big-tapered profiled ring disk

The Numerical Simulation about Cold Extrusion of Automotive Wheel Hub Bearing Rings

On the Fundamentals of Reverse Ring Rolling: A Numerical Proof of Concept

Simulation Study on the High-Speed Single-Point Accumulation Forming Process of Involute Spline

Evaluation Methods and Coupled Optimization at Macro- and Micro-Scales for Profiled Ring Rolling of Inconel718 Alloy

Analytical calculation model for radial-axial coordinated feed strategy in large-scale flat ring rolling based on ultimate bending moment