Abstract:In this study, ferrous iron (Fe 2+ )-catalyzed sodium percarbonate (2Na 2 CO 3 ·3H 2 O 2 ) was used for conditioning (referred to as F-N conditioning) municipal sludge. On this basis, Fe 2+ -catalyzed 2Na 2 CO 3 ·3H 2 O 2 was coupled with polymerized ferrous sulfate (PFS) conditioning (referred to as F-N-P conditioning) as well as coupled with the compounding of PFS and cationic polyacrylamide (CPAM) conditioning were explored (referred to as F-N-P-C conditioning) for municipal sludge. The results showed that the optimal dosages of Fe 2+ , 2Na 2 CO 3 ·3H 2 O 2 , PFS and CPAM were 15, 40, 200 and 0.3 mg/g of absolutely dry sludge (DS), respectively, in which the specific resistance of the sludge (SRF) and the water content of the filtered sludge cake (WC) dropped from 2.1 × 10 13 m/kg and 90.5 % to 2.9 × 10 11 m/kg and 75.3 %, respectively. The mechanism study showed that the hydroxyl radicals (•OH) generated by F-N-P-C effectively cleaved the extracellular polymer (EPS) and remodeled the protein secondary structure by affecting the ratio of α-sheet and β-helix in the proteins secondary structure. PFS and CPAM neutralized the negative charge on the surface of municipal sludge flocs, and adsorbed-bridged with sludge flocs to improve the settling performance of sludge. Finally, the results of the plate and frame filter press dewatering tests verified that the F-N-P-C conditioning mode was the best formulation of sludge conditioning and determined the optimal working conditions: sludge feeding time, pressing time and pressing pressure were 5400 s, 5400 s and 1.2 MPa, respectively. The chemical cost of F-N-P-C conditioning was preliminarily estimated as 58.55 USD$/ton DS. Therefore, The F-N-P-C process had certain practical value and promotion significance.

Study on Paper Mill Sludge Conditioning and Dewatering with Aluminium Polysilicate

Effect of Adding Alum Sludge from Water Treatment Plant on Sewage Sludge Dewatering

Preparation and Application of Slag Compound Flocculant

[Sludge Conditioning Performance of Polyaluminum, Polyferric, and Titanium Xerogel Coagulants].

Research on PSAFS for Printing and Dyeing Wastewater Treatment

Understanding the Impact of Chemical Conditioning with Inorganic Polymer Flocculants on Soluble Extracellular Polymeric Substances in Relation to the Sludge Dewaterability

Application Research of Depurate Sorts of Water Samples with the Polysilicate Aluminum Ferric Floccule

Improvement of alum and PACl coagulation by polyacrylamides (PAMs) for the treatment of pulp and paper mill wastewater

Study on the pretreatment of printing & dyeing wastewater with composite polyaluminum ferric flocculants

Combined conditioning of inorganic coagulant and polyamine to improve the dewaterability of municipal sludge, minimize dosage and reduce the influence of filtrate

Sludge Dewaterability with Combined Conditioning Using Fenton's Reagent and CPAM

Oxidation-flocculation conditioning to improve the performance and mechanism of municipal sludge dewatering

Study of sludge moisture distribution and dewatering characteristic after cationic polyacrylamide (C-PAM) conditioning

Study on the Coagulation of Polyaluminum Silicate Chloride(PASC)in Water Treatment

Enhancing the dewaterability of the municipal sludge by flocculant combined with skeleton builder

Combined Use of Inorganic Coagulants and Cationic Polyacrylamide for Enhancing Dewaterability of Sewage Sludge

Study on the flocculation condition of Poly-Silicate-Aluminum-Ferric (PSiAF) coagulant prepared with coal gangue as raw material

Using a combination of different conditioners to promote dewatering of digested sludge: Rheological characteristics

Mechanistic insights into chemical conditioning by polyacrylamide with different charge densities and its impacts on sludge dewaterability

Influences of Different Conditioners on Dehydration Ratio of Activated Sludge

A systematic investigation of peracetic acid oxidation and polymeric coagulants re-flocculation to enhance activated sludge dewatering: Multi-porous skeleton structures