Systematic research on rheological behavior for flocculants-conditioned sludge suspension
Guohong Feng,Zhi Hu,He Ma,Tiantian Bai,Yabing Guo
DOI: https://doi.org/10.5004/dwt.2020.25427
IF: 1.1
2020-01-01
Desalination and Water Treatment
Abstract:Rheology characteristics of raw sludge and cationic polyacrylamide (CPAM) conditioned sludge were both studied by steady test, thixotropy test, and dynamic test, respectively. Results of steady test showed Herschel–Bulkley, Bingham and Casson models could accurately describe the flow behavior of raw sludge and conditioned sludge, as the CPAM dosage was lower than 3 mg/g. An initial peak point for CPAM conditioned sludge at a low shear rate was observed, where the higher this peak was, the more energy was needed to break floc network. However, at a larger shear rate, the trend of rheogram was similar to that of raw sludge. Thixotropy was prominent for conditioned sludge, and the thixotropic loop was expanded with the increase of CPAM dosage. The strain sweep test demonstrated that the strength of floc network was intensified, leading to the larger elastic modulus. MGKV model which connected Maxwell model and series of Kelvin–Voigt modules was developed to characterize the creep recovery of sludge before and after conditioned. Furthermore, CPAM has more significant effect on delay time λ1, which reduced by about 90% as the dosage was up to 3.0 mg/g. A smaller value of λ1 explicated that conditioned sludge could restore to a new stable status in a shorter time. Compared to λ2 and λ3, λ1 has more significant dominance during the entire creep recovery test.
engineering, chemical,water resources