Abstract:Currently there still exist a large base of subcritical coal-fired boilers remaining in operation worldwide. Improving their thermal efficiency is critical for these units to reduce the cost of electricity and meet the increasingly stringent efficiency regulations. This paper presented an economic high temperature upgrading retrofit solution for these subcritical units in which the final superheat and reheat steam temperatures are elevated from 540 °C to 600 °C level while the steam pressures remain at subcritical such that the retrofit can be made with minimum modifications to the boiler to reduce retrofit cost and technical risk. A systematic analysis was first conducted to deduce the best boiler heating surface modification option to achieve such significant increase of boiler steam temperatures. The analysis shows that replacing part of the furnace water wall below the furnace exit with wall superheater is the most viable and economic boiler modification design. A three-dimensional computational fluid dynamics (CFD) simulation was then conducted for a typical 320 MW subcritical boiler design to verify the feasibility of this design and determine the area of furnace wall that needs to be modified to achieve the target steam temperatures. The results show that with only 3.6 m height of furnace wall replaced with wall superheater both the superheat and reheat steam temperatures can reach the target 600 °C level even without any modification made to the reheaters. With this heating surface modification design, the efficiency of the existing subcritical power plants can be improved considerably with minimum boiler retrofit work. More importantly, this technology is going to help the plant owners meet the increasingly stringent efficiency and emission regulations mandated by the government and place them in a better position to continue operating these units.

Calculation of Sirocco Circulating on Tubular Air Pre-Heater and Leak Proof Measurement

Calculate Sirocco Circulating on Tubular Air Pre-heater

TEST STUDY ON CONPREHENSIVE RETROFIT OF BOILER’S HEAT RECOVERY SURFACE

Appliacation of spiral-finned tubes economizer in the improvement of boiler energy saving technical reconstruction

Technical Measures for Reducing Air Leakage Rate of Rotary Air Preheater

Wear in low temperature reheater and low reheat steam temperature:reason analysis and retrofitting

Study on Hot Air of High-temperature Area Outside The Boiler in Power Plants

The Study on Technical Retrofit for 125MW Grade Boiler Air Preheater

Retrofit of Air Preheater of 670 T／h Boiler in Xinhai Power Generation Company Ltd

Study on Energy Efficiency of 35mwth Oxygen-fuel Boiler with Recirculated Flue Gas

Analytical and numerical investigations on the high temperature upgrading solution of subcritical boilers

Experiment and Investigation of Overheating Problem of 300MW Boiler's HT Reheater

Steam Temperature Characteristics in Boiler Water Wall Tubes Based on Furnace CFD and Hydrodynamic Coupling Model

Study on Model of Ash Fouling Monitoring in Rotary Air Preheater of Coal-Fired Power Plant Boiler

Economic Analysis and Operation Simulation of Low Pressure Economizer System in 135 Mw Thermal Power Plant

Combination Utilization of Air Preheater with Low-Pressure Economizer in MSW Incineration Power Plants

Experimental Study of Intermediate Header Flow Distribution Characteristics of a Supercritical Once-through Boiler Operating at Variable Pressures

Simulation test and energy efficiency analysis of flue gas heat deep recovery of thermal power plants

Effect of improving reheat steam temperature on boiler thermal performance and economic analysis

Local overheating - a factor affecting the thermoeconomy and reliability of coal-fired utility boilers and its some improvement countermeasures

On-line monitoring of ash fouling and soot-blowing optimization for convective heat exchanger in coal-fired power plant boiler