Heavy Metals Removal by Hydroxide Precipitation and Coagulation-Flocculation Methods from Aqueous Solutions
Fong Moi Pang,Sheau Ping Teng,Tjoon Tow Teng,A.K. Mohd Omar
DOI: https://doi.org/10.2166/wqrj.2009.019
2009-05-01
Water Quality Research Journal
Abstract:Abstract The hydroxide precipitation and coagulation-flocculation methods were used to treat wastewater containing lead, zinc, copper, and iron. The concentrations of heavy metals in the synthetic wastewater range from 1 to 14 mg/L for lead, 5 to 90 mg/L for zinc, 3 to 90 mg/L for copper and 5 to 45 mg/L for iron. Individual Zn(II) and Cu(II) with concentrations below 90 mg/L and Fe(III) with concentrations below 45 mg/L were removed up to 99% by the precipitation method in the pH range of 8.7 to 9.6, 8.1 to 11.1, and 6.2 to 7.1, respectively. Though the highest percent removal of Pb(II) by hydroxide precipitation alone was approximately 98%, the final dissolved concentrations did not fulfill the Standard A discharge limit required by the regulations, thus further treatment by the coagulation-flocculation process was performed. Aluminum sulphate (alum), polyaluminum chloride (PACl) and magnesium chloride (MgCl2) have been used as coagulants together with Koaret PA 3230 as coagulant aid to determine the effectiveness of the coagulation method for the removal of individual heavy metals in the wastewater. The effects of parameters such as pH, type, and dosage of coagulant on the percentage of metal removal, and the amount of coagulant aid on the flocs settling time were investigated. The jar test showed that up to 99% removal of Pb(II) was attained by the addition of 1,200 mg/L of alum, 150 mg/L of PACl, and 2,000 mg/L of MgCl2 in a pH range of 6.5 to 7.8, 8.1 to 8.9, and 9.7 to 10.9, respectively.