Abstract:Multi-metal extraction of flue dust from copper smelting is being pursued to meet the increasingly appealing environmental requirements of our modern life. In this paper, the thermodynamic analysis of acid leaching solution was carried out. Ferric arsenate deposits were found in the range of pH = 0∼11.63, in the form of FeAsO4 and FeAsO4∙2H2O. Cu2AsO4OH, CuHAsO4, and Cu5H2(AsO4)4 forms of Cu2AsO4 were produced in the range of pH = 0.98∼2.33. Zn3(AsO4)2, Zn2AsO4OH, ZnHAsO4, and Zn5H2(AsO4)4 forms of zinc arsenate were produced in the range of pH = 1.40∼4.85. Theoretically, when pH = 0.98∼2.33, copper arsenate salt was produced; however, when the actual experimental results were at pH ≥ 1.2, a small amount of copper co-settling occurred. Theoretical results were verified by single factor experiments. Strictly controlling the pH value of the reaction system can effectively separate arsenic (As) from copper (Cu) and zinc (Zn). Through single factor experimentation, optimal process parameters of iron salt and calcium salt combined with As removal were as follows: reaction time, 5 h; reaction temperature, 85 °C; pH value, 1.2; Fe-As molar ratio, 1.5; no H2O2 added. Under these conditions, the precipitation rate of As was 89.12%, while Cu and Zn did not precipitate. Through XRD analysis, As element was removed from acid leaching solution in the form of scorodite (FeAsO4∙2H2O). This has laid a theoretical foundation for the effective removal of As in acid leaching solution and the reduction of As content.

Removal of arsenic and metal ions from acidic effluents via the Fenton reaction method

Arsenic Removal in Synthetic Ground Water Using Iron Electrolysis

Long-term Stability of the Fe(III)–As(V) Coprecipitates: Effects of Neutralization Mode and the Addition of Fe(II) on Arsenic Retention

Effective As(III) and As(V) Immobilization from Aqueous Solution by Nascent Ferrous Hydroxide Colloids (FHC)

Arsenic removal from acid extraction solutions of copper smelting flue dust

Removal of Arsenic from Acid Wastewater Via Sulfide Precipitation and Its Hydrothermal Mineralization Stabilization

Fundamental research on selective arsenic removal from high-salinity alkaline wastewater

Removal of arsenic from “Dirty acid” wastewater via Waelz slag and the recovery of valuable metals

Rapid Abiotic As Removal from As-rich Acid Mine Drainage: Effect of Ph, Fe/As Molar Ratio, Oxygen, Temperature, Initial As Concentration and Neutralization Reagent

Advantages of Aeration in Arsenic Removal and Arsenite Oxidation by Structural Fe(II) Hydroxides in Aqueous Solution

A Study on the Removal of Arsenic from Leaching Liquor of Arsenic-containing Alkaline Dregs by Precipitation As Ferric Arsenates

Effect of pH on oxygen-induced abio-oxidation and removal of As from As-rich acid mine drainage in the co-existence of Zn(II)

An Innovative Strategy for Efficient and Economical Arsenic Removal in Hydrometallurgical Waste Sulfuric Acid by Co-Treatment with Fe–As Coprecipitation Residue Via Scorodite Formation

Application and Mechanism of Fenton-like Iron-Based Functional Materials for Arsenite Removal

Effect of co-existent Al(III) in As-rich Acid Mine Drainage (AMD) on As removal during Fe(II) and As(III) abiotic oxidation process

Removal and immobilization of arsenic from copper smelting wastewater using copper slag by in situ encapsulation with silica gel

Leaching and removal of arsenic with waste acids from arsenic pre-removed dusts discharged from furnaces for pyrometallurgical refining of copper

Study on Treatment of Smelting Contaminated Acid by Evaporation Condensing Process

Immobilization of arsenic in tailing by using iron and hydrogen peroxide

A combined abiotic oxidation-precipitation process for rapid As removal from high-As(III)-Mn(II) acid mine drainage and low As-leaching solid products