Abstract:In the presence of styrene (St), the melting-grafting of maleic anhydride (MAH) onto polypropylene was conducted in Haake torque rheometer and twins screw extruder (TSE) respectively. In experiments the dicumyl peroxide (DCP) concentration, St concentration, MAH concentration, reaction time, reaction temperature and screw speed were varied respectively. Results show that with the DCP concentration increasing, both the grating degree of MAH and melt flow index (MFR) of the grafted product increase at first and then deerease. When maintaining MAH concentration and increasing St concentration, the grafting degree of MAH reaches maximum at St:MAH=1mol?mol?1 and MFR always keeps decreasing. When maintaining St concentration and increasing MAH concentration, the grafting degree of MAH increases at first and then slightly decreases, and during which the MFR has a maximum point. With the reactive time increasing, both the grating degree of MAH and MFR of the grafted product increase at first and then decrease. When temperature is too high, the grafting degree of MAH decreases and the scission of the grafted product increases. When screw speed is low, the grating degree of MAH is low too, and when screw speed is high, the scission of the grafted product increases. The grafting of MAH in TSE is lower than that in Haake torque rheometer, while MFR of the grafted product in TSE is much lower than that in Haake torque rheometer. Based on the mechanism of melt-grafting, the above experimental results were discussed and explained.

THE ADHESIVENESS BETWEEN ALUMINIUM AND HOT MELT ADHESIVE USED IN PP-R PLASTIC-ALUMINUM STEADY PIPE

Regulation of Structure and Mechanical Properties of Poly(propylene-Butene) Alloys by Monomer Composition Switching

Study on Melt-Grafting of Maleic Anhydride Onto Polypropylene in the Presence of Styrene

Test Research on Water Resistant Performance of Hot Melt Adhesive in Plastic Pipe Reinforced by Cross-winding Steel Wires

Modeling the Interfacial De-Bonding Behavior Between Steel Wire and Adhesive

Investigation of Interfacial Debonding Between Steel Wire and Adhesive Resin

Effect of Modified Polypropylene on the Interfacial Bonding of Polymer–aluminum Laminated Films

Micro-nano interfacial mechanical interlocking structure-property of the ultrasonic-assisted hot press molded polypropylene/aluminum alloy hybrid

Influence of Γ-Aminopropyltriethoxy on Shear Strength of Adhesion Bonded Aluminum Sheet/Polypropylene/Aluminum Sheet

Study on properties of AS 615 as hot melt adhesive film based on polyester

Effect of Co-Monomer on the Adhesive Performance of PP-g-MAH Between Cast Polypropylene Film and Aluminum Foil

An Adhesion Improvement of Low-Density Polyethylene to Aluminum through Modification with Functionalized Polymers

Hot melt adhesive properties of PA/TPU blends compatibilized by EVA-g-MAH

Investigation On Shear Strength Of Steel-Polymer Adhesive Interface In Plastic Pipe Reinforced By Cross Helically Wound Steel Wires

Study on the interfacial interactions and adhesion behaviors of variouspolymer-metalinterfaces in nano molding

Interface Physical Influence on Mechanic Properties of PP/AS Modified Polymer Caused by Maleic Anhydride

Study on effect of injection temperature on shear strength of the direct bond between polyphenylene sulfide and anodized aluminum alloy

Data Analysis on Adhesive Property Testing Methods of Hot-melt Pressure-sensitive Adhesive with Styrene Thermoplastic Elastomer

Study on Preparation and Properties of Polyester Hot Melt Adhesive for Electronic Industry

Influence of silane coupling agents on the interfacial structure and properties of modified polypropylene/aluminum alloy composites prepared by hot-press molding

Grafting of Chlorinated Polypropylene and Its Adhesion to Polypropylene