Abstract:The presence of oxide-MnS complex inclusions is beneficial for the improvement of hydrogen resistance in pipeline steel. The effect of S and Mg contents on the generation mechanism of MnS, MgAl 2 O 4 , and MgO inclusions, and the heterogeneous nucleation principle of MnS on the surfaces of MgAl 2 O 4 and MgO were revealed using laboratory experiments, thermodynamic calculations, and density functional theory (DFT) computations. The inclusion characteristics in steel were evaluated by using a Scanning Electron Microscope in combination with an Energy Dispersive Spectrometer (SEM + EDS). It has been found that as the Mg content increased, MgAl 2 O 4 transformed into MgO, which can be well predicted by thermodynamic calculations. It was found that MnS exhibited the ability to nucleate heterogeneously on the surfaces of MgO and MgAl 2 O 4 inclusions. Furthermore, proper S content (approximately 30 ppm) can facilitate the formation of oxide-MnS complex inclusions, excess S content was not desired. The smaller the oxide inclusion, the easier to form wrapped MnS on the oxides. The nucleation ability of MnS and MgAl 2 O 4 was identified by DFT calculations and found that they followed the order of (111) MnS //(111) MgAl2O4 >(100) MnS //(100) MgAl2O4 >(110) MnS //(110) MgAl2O4 . Furthermore, the heterogeneous nucleation ability of MnS and MgO followed in the order of (111) MnS //(111) MgO > (100) MnS //(111) MgO > (100) MnS //(100) MgO . This study provides theoretical evidence supporting the heterogeneous nucleation ability of MnS on the surfaces of MgO and MgAl 2 O 4 . Moreover, it helps bridge the disparity between the calculation of MnS and MgO nucleation using the two-dimensional mismatch degree and the experimental findings.

Preparation of Manganic Manganous Oxide Control-Sample Containing Sulfur

Mechanistic Study on the Enhanced SO2-tolerant Ability of CuCl2-promoted MnOx-CeOx Mixed Oxide for Hg0 Removal

Evaluation of Crystalline Structure and SO2 Removal Capacity of a Series of MgAlFeCu Mixed Oxides As Sulfur Transfer Catalysts

The Formation of Manganous Dithionate in the Manganese Oxide Flue Gas Desulfurization

A Precise and Specific Method for Quick Determination of Sulfur Fumigation for Moutan Cortex

Sulfur Dioxide Capture by Heterogeneous Oxidation on Hydroxylated Manganese Dioxide.

Structure and properties of MgAlCuFe complex oxide for FCC desulfurization: effect of Fe and Cu contents

Properties of MgAlCuFe Complex Oxides for FCC Desulfurization: Effect of Metal Salt Precursors

Influence of the Chemical Composition of MgAlFeCu Mixed Oxides As Catalysts for SO2Removal

Heterogeneous Formation of Sulfur Species on Manganese Oxides: Effects of Particle Type and Moisture Condition.

Preparation of chemical manganese dioxide from low-grade rhodochrosite ore

Study on Co-precipitation Experiment of Calcium Sulfite and Calcium Sulfate

The recycling of sulphur in waste and conversion to manganese sulphate: Process optimization, kinetic study, mechanistic insights

Removal and Resource Utilization of High Concentration Flue Gas Sulfur Dioxide Using Manganese Carbonate Ore

Mass Transfer and Kinetics Study on the Sulfite Forced Oxidation with Manganese Ion Catalyst

Preparation of Mn Acid Lithium with Spherized Chemical Mn Dioxide

Effect of sulfur content on precipitation behaviour of MnS-containing inclusions in X70 pipeline steel

Determination of total sulfur in soil and plant samples using sodium bicarbonate/silver oxide, dry ashing and ion chromatography

Study on the Methods Determining the Sulfide in Water

Study on Preparation of Thiomolybdate with New Suifidizing Agent

Analysis on Calcium Based Sulphur- fixation Reagent hydration Active