Safe, accurate, and precise sulfur isotope analyses of arsenides, sulfarsenides, and arsenic and mercury sulfides by conversion to barium sulfate before EA/IRMS
Jorge E. Spangenberg,Nicolas J. Saintilan,Sabina Strmić Palinkaš
DOI: https://doi.org/10.1007/s00216-021-03854-y
2022-01-23
Analytical and Bioanalytical Chemistry
Abstract:Abstract The stable isotope ratios of sulfur ( δ 34 S relative to Vienna Cañon Diablo Troilite) in sulfates and sulfides determined by elemental analysis and isotope ratio mass spectrometry (EA/IRMS) have been proven to be a remarkable tool for studies of the (bio)geochemical sulfur cycles in modern and ancient environments. However, the use of EA/IRMS to measure δ 34 S in arsenides and sulfarsenides may not be straightforward. This difficulty can lead to potential health and environmental hazards in the workplace and analytical problems such as instrument contamination, memory effects, and a non-matrix-matched standardization of δ 34 S measurements with suitable reference materials. To overcome these practical and analytical challenges, we developed a procedure for sulfur isotope analysis of arsenides, which can also be safely used for EA/IRMS analysis of arsenic sulfides (i.e., realgar, orpiment, arsenopyrite, and arsenian pyrite), and mercury sulfides (cinnabar). The sulfur dioxide produced from off-line EA combustion was trapped in an aqueous barium chloride solution in a leak-free system and precipitated as barium sulfate after quantitative oxidation of hydrogen sulfite by hydrogen peroxide. The derived barium sulfate was analyzed by conventional EA/IRMS, which bracketed the δ 34 S values of the samples with three international sulfate reference materials. The protocol (BaSO 4 -EA/IRMS) was validated by analyses of reference materials and laboratory standards of sulfate and sulfides and achieved accuracy and precision comparable with those of direct EA/IRMS. The δ 34 S values determined by BaSO 4 -EA/IRMS in sulfides (arsenopyrite, arsenic, and mercury sulfides) samples from different origins were comparable to those obtained by EA/IRMS, and no sulfur isotope fractionations were introduced during sample preparation. We report the first sulfur isotope data of arsenides obtained by BaSO 4 -EA/IRMS. Graphical abstract
chemistry, analytical,biochemical research methods