Abstract:Background Reference dosimetry in ultra‐high dose rate (UHDR) beamlines is significantly hindered by limitations in conventional ionization chamber design. In particular, conventional chambers suffer from severe charge collection efficiency (CCE) degradation in high dose per pulse (DPP) beams. Purpose The aim of this study was to optimize the design and performance of parallel plate ion chambers for use in UHDR dosimetry applications, and evaluate their potential as reference class chambers for calibration purposes. Three chamber designs were produced to determine the influence of the ion chamber response on electrode separation, field strength, and collection volume on the ion chamber response under UHDR and ultra‐high dose per pulse (UHDPP) conditions. Methods Three chambers were designed and produced: the A11‐VAR (0.2–1.0 mm electrode gap, 20 mm diameter collector), the A11‐TPP (0.3 mm electrode gap, 20 mm diameter collector), and the A30 (0.3 mm electrode gap, 5.4 mm diameter collector). The chambers underwent full characterization using an UHDR 9 MeV electron beam with individually varied beam parameters of pulse repetition frequency (PRF, 10–120 Hz), pulse width (PW, 0.5–4 μs), and pulse amplitude (0.01–9 Gy/pulse). The response of the ion chambers was evaluated as a function of the DPP, PRF, PW, dose rate, electric field strength, and electrode gap. Results The chamber response was found to be dependent on DPP and PW, and these dependencies were mitigated with larger electric field strengths and smaller electrode spacing. At a constant electric field strength, we measured a larger CCE as a function of DPP for ion chambers with a smaller electrode gap in the A11‐VAR. For ion chambers with identical electrode gap (A11‐TPP and A30), higher electric field strengths were found to yield better CCE at higher DPP. A PW dependence was observed at low electric field strengths (500 V/mm) for DPP values ranging from 1 to 5 Gy at PWs ranging from 0.5 to 4 μs, but at electric field strengths of 1000 V/mm and higher, these effects become negligible. Conclusion This study confirmed that the CCE of ion chambers depends strongly on the electrode spacing and the electric field strength, and also on the DPP and the PW of the UHDR beam. A significant finding of this study is that although chamber performance does depend on PW, the effect on the CCE becomes negligible with reduced electrode spacing and increased electric field. A CCE of ≥95% was achieved for DPPs of up to 5 Gy with no observable dependence on PW using the A30 chamber, while still achieving an acceptable performance in conventional dose rate beams, opening up the possibility for this type of chamber to be used as a reference class chamber for calibration purposes of electron FLASH beamlines.

An ionization chamber developed for the facility of heavy ions therapy at IMP

Prototype Design of Readout Electronics for In-Beam TOF-PET of Heavy-Ion Cancer Therapy Device

Special Way of Increasing Linear Energy Transfer Value Used for Study on Single Event Effect

A Multi-Anode Transverse Field Gas Ionization Chamber

Design of Ionization Chamber for CLAPA II

Characterization and performances of a monitoring ionization chamber dedicated to IBA-universal irradiation head for Pencil Beam Scanning

A dedicated in-beam PET system with a modular dual-head for radiotherapy imaging in HIMM

A Compact Spectrometer for Heavy Ion Experiments in the Fermi Energy Regime

Development of a 50 kV hydrogen–helium mixed ion beam implanter

Dosimetric verification on HIMM at the Wuwei heavy ion therapy center using anthropomorphic phantoms

Gas Ionization Chamber for Particle Identification at RIBLL

Nanodosimetric investigation of the track structure of therapeutic carbon ion radiation. Part 1: Measurement of ionization cluster size distributions

3. Research Center for Charged Particle Therapy A. Research on the Use of Heavy Ion Beams for Cancer Radiotherapy. ‡@ Development of Advanced Cancer Radio- Therapy with Charged Particle

A multiple sampling ionization chamber for the External Target Facility

CW/Pulsed H− Ion Beam Generation with PKU Cs-free 2.45 GHz Microwave Driven Ion Source

Assessment of the induced radioactivity in the treatment room of the heavy-ion medical machine in Wuwei using PHITS

Possibility of Generating H+, or H2+, or H3+ Dominated Ion Beams with a 2.45 GHz Permanent Magnet ECR Ion Source

Development of novel ionization chambers for reference dosimetry in electron flash radiotherapy

Secondary particle intensity for experimental range verification in carbon ion therapy

The Proportional Ion Chamber and its Corresponding Circuit

Spectral Performance of CsI(Tl) Crystals Developed at IMP