Abstract:U is a long-lived radioactive isotope with a half-life of 2.342(3) ×10 a, which produced principally by thermal neutron capture on U. U is potentially applied in geological research and nuclear safeguards. Accelerator mass spectrometry (AMS) is presently the most sensitive technique for the measurement of U. A method for AMS measurement of long-lived heavy ion U was developed at CIAE with the set up the AMS dedicated injector and the newly proposed PbO2 molecular ions for the simulation of U ion transport. A sensitivity of lower than 10 has been achieved for isotopic ratio U/U in present work. INTRODUCTION U is a long-lived radioactive isotope with a half-life of 2.342(3) ×10 a, mainly produced by the thermal neutron induced U(n,γ) U reaction. The isotopic ratio of U/U in nature is about 10, depending strongly on the integral thermal neutron flux received by the material. This makes U usable as an integrating neutron monitor over the last 100 million years [1], and potentially applicable in geological research [2]. The isotopic ratio of U/U could also be used as a “fingerprint” for indicating the presence of neutronirradiated uranium usually originated from nuclear activities [3]. Recently, several efforts have been made to measure U in environmental samples using techniques based on mass spectrometry such as high-resolution inductively coupled plasma spectrometry (HR-ICPMS), thermal ionization mass spectrometry (TIMS) and accelerator mass spectrometry (AMS). However, detection limits with conventional mass spectroscopy for U/U are ~10, leading to errors larger than 50% for uranium ore samples[4, 5]. Therefore the measurement of natural U is difficult or even impossible without AMS. AMS offers significant advantages over conventional mass spectroscopic methods in high sensitivity, smaller sample size, relatively free from isomer and molecular-ion interferences, and shorter measurement time. AMS measurement of actinides was presented firstly by IsoTrace facility X.L. Zhao et al. of Toronto group [6], in which the U/U is lower than 5×10 in a natural uranium ore from Cigar Lake deposit in Canada. The natural U/U has also been measured by several other groups, such as: VERA [7], ANU [8], LLNL [9], ANSTO [10], Munich [11], ETH [12] and Israel Weizmann Institute [13]. In this paper, a method for AMS measurement of longlived heavy ion U developed on the HI-13 Accelerator at China Institute of Atomic Energy (CIAE) is reported. The unique features include establishing of the AMS dedicated injector and the newly proposed PbO2 molecular ions for the simulation of U ion transport. THE AMS DEDICATED INJECTOR There is a general rule in AMS that a high mass resolution analyzer is needed to separate the neighboring interference and a high energy resolution analyzer is required to clip the tail of the high energy. The original injector setup at CIAE [14] with the mass resolution of M M Δ ~220, could not satisfy the requirement for AMS measurement of heavy isotopes (e.g., U, Hf, Sm). Therefore, a high resolution dedicated injector for AMS was developed, as shown in Fig. 1. The new injector adopts achromatic technique, which consists of a 90o electrostatic analyzer (ESA) and a 112o double-focusing analyzing magnet (MA). A triplet electric quadruple lens and a single electric quadruple lens were mounted at the entrance and the exit of the ESA beam line, respectively, for ions focusing. This spherical 90o ESA with 750 mm radius, has maximum electric field strength of 4 kV/cm and provides both horizontal and vertical focusing. The 112o double-focusing MA with a bending radius of 800 mm, has a maximum magnetic field of 1.3 T. The energy resolution of the electrostatic deflector

A multiple sampling ionization chamber for the External Target Facility

Prototype Design of Readout Electronics for In-Beam TOF-PET of Heavy-Ion Cancer Therapy Device

The Charged Fragment Detector System of the External Target Facility

Accelerator mass spectrometry for long-lived heavy ion 236 u at ciae *

A miniature prototype of Time Projection Chambers for CSR External-Target Experiment

The Drift Chamber Array at the External Target Facility in HIRFL-CSR

Development of a portable gas-filled ionization chamber

A Compact Spectrometer for Heavy Ion Experiments in the Fermi Energy Regime

New trapezoid-shaped Frisch-grid ionization chamber for low-energy particle measurements

MITA: A Multilayer Ionization-chamber Telescope Array for low-energy reactions with exotic nuclei

Gas Ionization Chamber for Particle Identification at RIBLL

Detection of correlated fission fragments with a twin Frisch-grid ionization chamber

An ionization chamber developed for the facility of heavy ions therapy at IMP

Emulsion Cloud Chamber technique to measure the fragmentation of a high-energy carbon beam

High-rate axial-field ionization chamber for particle identification of radioactive beams

Fudan Multi-purpose Active TArget Time Projection Chamber (fMeta-TPC) for Photonnuclear Reaction Experiments

Improving the particle identification of radioactive isotope beams at the RIBLL2 separator

Fudan Multi-Purpose Active Target Time Projection Chamber (Fmeta-Tpc) for Photonuclear Reaction Experiments

Identification of α particles and fission fragments emitted by 252 Cf using a fission time projection chamber

A Transverse Field Gas Ionization Chamber Performed at RIBLL

Development of an atomic spectra research platform based on a 30-keV electron beam ion trap