Abstract:The major barriers for applying carbon dioxide (CO2) capture technology to coal-fired power plants in China and worldwide are the consequent drop in power plant energy efficiency and significantly higher cost of electricity (COE). This paper proposes a new perspective for determining the most cost-efficient CO2 capture ratio using a modeling and simulation approach that balances the per unit parasitic energy consumption for absorbent regeneration with the per unit capital cost of the CO2 capture unit of a coal-fired power plant. Using a typical 550 MW supercritical pulverized coal-fired power plant in China as the reference plant, with monoethanolamine (MEA) absorption unit for CO2 capture, a process model of the power generation unit together with the MEA CO2 capture unit was developed and detailed process simulations were conducted with the model. Then, a sensitivity analysis was then conducted to study the impact on key plant behavior indicators, including per unit energy penalty for absorbent regeneration, net power output and power generation efficiency, total capital cost of the power plant together with the MEA CO2 absorption unit, per unit capital cost of the MEA unit, COE, as well as the per unit CO2 avoidance cost (indicated by cost per tonne (t) CO2 avoided), across a CO2 capture ratio range between 20% and 99%. The results show that when CO2 capture ratio is low, while the unit energy consumption for absorbent regeneration per tCO2 avoided increases steadily with the increase of CO2 capture ratio, the cost per tCO2 avoided decreases as the MEA absorption train is scaled up given the high capital cost of each MEA train. After CO2 capture ratio reaches certain level (60% for this plant), the cost per tCO2 avoided starts to increase with CO2 capture ratio, since the unit energy consum- - ption for absorbent regeneration per tCO2 avoided has increased to so high that it supplants the scaling effect of the MEA train and becomes the dominant factor that determines the increase or decrease trend of the cost per tCO2 avoided. Besides, due to the physical restraint on the upper bound of CO2 capture capability of one single MEA train by the diameter of the absorber, an additional MEA train is needed when the CO2 capture ratio increases to certain points (40% and 85% for this plant), resulting in jumps of several parameters including the total capital cost for the power plant and MEA CO2 capture unit, per unit capital cost for the MEA CO2 capture unit, and last the cost per tCO2 avoided. Based on all these result, finally a cost-optimal CO2 capture ratio of 40% (365 RMB/tCO2-_avoided) was obtained, which is easier for the power plant to bear while realizing a significant reduction in CO2 emission of this plant. Therefore, applying this approach for determining CO2 capture ratios could help minimize the barrier for the initiation of carbon dioxide capture and storage (CCS) in China's power industry. Besides, future replacement or improvement for the MEA CO2 capture technology has the potential to further reduce the cost per tCO2 avoided, which needs special attention.

Comparison of cost of CO_2 capture (CC) systems with consideration of technological learning effect

Learning Rates and Cost Reduction Potential of Indirect Coal-to-liquid Technology Coupled with CO2 Capture

Post-combustion CO2 capture from a natural gas combined cycle power plant using activated carbon adsorption

Analysis and optimization of post-combustion CO2capture system based on chemical absorption

Progress and Prospect of CCS in China: Using Learning Curve to Assess the Cost-Viability of a 2×600MW Retrofitted Oxyfuel Power Plant As a Case Study

Research progress of pre-combustion CO2 capture

Postcombustion Capture or Direct Air Capture in Decarbonizing US Natural Gas Power?

Process Design and Optimization of State‐of‐the‐art Carbon Capture Technologies

A review of techno-economic models for the retrofitting of conventional pulverised-coal power plants for post-combustion capture (PCC) of CO2

Cost and Performance of Power Plants with CO_2 Capture

The Prospects of Carbon Capture and Storage in China’s Power Sector under the 2 °C Target: A Component-based Learning Curve Approach

Techno-economic Analysis of Carbon Capture and Utilization Technologies and Implications for China

Cost of Carbon Capture and Storage and Renewable Energy Generation Based on the Learning Curve Method

Experimental Study on Postcombustion Systems Including a Hollow Fiber Membrane and a Packed Column

An update of the benchmark post-combustion CO2-capture technology

The economics of clean coal power generation with carbon capture and storage technology in China

Techno-economic Analysis of Integrated Carbon Capture and Utilisation Compared with Carbon Capture and Utilisation with Syngas Production

Reducing initial barriers for CCS deployment on pulverized coal-fired power plants in China by optimizing the capture ratio of carbon dioxide

CO2 Capture Analysis in Different Combustion Methods for CO2 Utilisation and Storage

Understanding cost reduction of China's biomass direct combustion power generation—A study based on learning curve model

Mapping the economy of coal power plants retrofitted with post-combustion and biomass co-firing carbon capture in China