Abstract:This study presents the development of an improved technique for viscosity measurements under high pressure. The apparatus is based on the principle of the falling ball viscometer, implemented in a high-pressure autoclave fitted with visualisation windows. The originality here is that the balls fall through a tube open at both ends with a diameter slightly greater than that of the balls, allowing a simplified modelling and numerical simulation. A numerical approach has been used for viscosity determination. Calculations have been made with COMSOL Multiphysics® with the laminar Navier–Stokes model for Newtonian mixtures. It includes the specific hydrodynamic effects without the need for a calibration fluid. However, validation experiments were carried out at atmospheric pressure with dimethylsulfoxide (DMSO) at 298, 308 and 318K and with cocoa butter at 313 and 353K, with values of viscosity in the range from 1.4 to 45.4mPas. Comparative measurements with literature data have been conducted with cocoa butter saturated with carbon dioxide at 313 and 353K and for pressures ranging from 0.1 to 25MPa. At 313K, viscosity varies from 45.4mPas to 3.1mPas while at 353K it varies from 12.4 to 1.9mPas. For both isotherms tested, within the range 0–15MPa, the higher the CO2 dissolution in the cocoa butter, the lower the viscosity. However, this decrease in viscosity is more pronounced at the lowest temperature. Above 15MPa the CO2 dissolution effect on viscosity becomes insignificant, i.e. within the experimental error, due to a counter effect linked with the high hydrostatic pressure. Furthermore, the limits of use of this method have been determined. This technique is revealed as reliable and can therefore be used with other binary systems.

Development of Vibrating-Wire Viscometer for Liquid at High Pressure

Bubble Shape and Rising Velocity in Viscous Liquids at High Temperature and Pressure

Validation of an accurate vibrating-wire densimeter: Density and viscosity of liquids over wide ranges of temperature and pressure

Development of a Viscosity Measuring Device for Low Boiling Point Refrigerant Mixtures

A New Method for Liquid Viscosity Measurements: Inclined-Tube Viscometry

A two-capillary viscometer for temperatures up to 473 K and pressures up to 100 MPa – operation and verification at low pressure

Development of an improved falling ball viscometer for high-pressure measurements with supercritical CO2

Simultaneous measurement of density and viscosity of n-pentane from 298 to 383 K and up to 100 MPa using a vibrating-wire instrument

A Switched Vibrating-Hot-wire Method for Measuring the Viscosity and Thermal Conductivity of Liquids

Two-capillary viscometer for temperatures and pressures relevant to CO 2 capture, transport, and storage – operation and improved analysis at high pressure

The Velocity and Elastic Constants in Fluid Oxygen under High Pressures and High Temperature

Liquid Viscosity Measurement Using a Vibrating Flexure Hinged Structure and a Fiber-Optic Sensor

Liquid Viscosity Measurement Method in the Pressure Range of 0.1 ～ 0.5 MPa Based on Couette Rheometer

Design and Fabrication of a Microfluidic Viscometer Based on Electrofluidic Circuits

New silicon micromechanical resonant viscosity vacuum gage

Electromagnetically spinning viscometer designed for measurement of low viscosity in low shear rate region

High Pressure Raman Spectra of Silicone Oil

Liquid Density Measurement in High-Pressure Region Using Quartz Crystal Resonators

Development of Viscosity Real-time Measurement System Based on Capillary Method

In Situ Brillouin Scattering Study of Water in High Pressure and High Temperature Conditions

Study on Measurement of Liquid Viscosity Coefficient