Abstract:Abstract Super abrasive diamond grinding wheels are the most promising tools for the precision machining of advanced ceramics and carbide materials. However, the efficiency of conventional conditioning of these tools is limited owing to high dressing tool wear, long process time, low form flexibility, and induced damage to the abrasive grains. Wire electrical discharge machining (WEDM) is an alternative method for conditioning of superabrasive grinding wheels with electrically conductive bonding materials. In this study, cylindrical plunge grinding of an alumina ceramic with a resin-bonded diamond grinding wheel is investigated. The assigned type of resin bond contains copper particles and is accordingly electrically conductive for wire electrical discharge conditioning (WEDC). Conventional (mechanical) and WEDC methods are used for generating the same profile on two similar diamond grinding wheels. As a result, the specific grinding energy was reduced up to 26% and 29% during rough and finish plunge grinding, respectively. Reduced specific grinding energy and forces, along with more effective grain protrusion and sharpness by using WEDC for profiling of grinding wheels, have contributed positively to the ground surface conditions despite the relatively rougher wheel surface topography in comparison to the conventional profiling. The more considerable reduction in the mean roughness depth (Rz) than in the arithmetical mean roughness value (Ra) (11% smaller Rz values in WEDC versus mechanical conditioning) verifies that the workpiece surface underwent less surface degradation in case of WEDC because of smaller grinding forces. Furthermore, the profile wear behavior of the workpiece ground with the WED conditioned grinding wheel was superior to the conventionally conditioned one.

Electrical Discharge Grinding of Polycrystalline Diamond

Research on Electronic Discharge Grinding of Polycrystalline Diamond Based on Response Surface Method

Edge fabrication and process optimization of precision woodworking PCD millers with disk electrical discharge machining

Study on Electrical Discharge and Ultrasonic-Assisted Mechanical Combined Machining of Polycrystalline Diamond

On-machine Electric Discharge Truing of Small Ball-End Fine Diamond Grinding Wheels

Electrochemical Discharge Grinding of Metal Matrix Composites Using Shaped Abrasive Tools Formed by Sintered Bronze/diamond

Experimental study on surface physical behaviour and integrity of polycrystalline diamond (PCD) in micron-scale abrasive flow assisted impulse-discharge machining

A Study on Micro-Hole Machining of Polycrystalline Diamond by Micro-Electrical Discharge Machining

Research on the grinding performance of grinding wheel in the initial grinding stage after electric spark dressing of grinding wheel

Comparative Study of Ultrasonic Vibration-Assisted Die-Sinking Micro-Electrical Discharge Machining on Polycrystalline Diamond and Titanium

Grinding efficiency and profile accuracy of diamond grinding wheels dressed with wire electrical discharge conditioning (WEDC)

An Analysis of the Tool Electrode Working Mechanism of Grinding-Aided Electrochemical Discharge Machining of MMCs

Grinding-aided electrochemical discharge machining of particulate reinforced metal matrix composites

Precision dressing of arc-shaped coarse-grained diamond wheels via electrical discharge aided grinding technology

Experimental Investigation on the Discharge Stability in Micro-Edm Based on Finite-Successive Pulses Discharge Method

Abrasive Electrodischarge Grinding (Aedg) Of Silicon Nitride

Investigation of the Material Removal Mechanism in Electrochemical Discharge Drilling Using a High-Speed Rotating Helical Tool-Electrode

Electrical Discharge Machining of Metal Matrix Composites with A High Speed Non-Round Electrode

High-speed Near Dry Electrical Discharge Machining

Surface Integrity of Binderless WC Using Dry Electrical Discharge Assisted Grinding

Electrical Discharge Truing of a Vitrified Bonded Superabrasive Wheel with Electrical Conductivity