Abstract:In this paper, the aerodynamic performance of the S series of wind turbine airfoils with different relative cambers and their modifications is numerically studied to facilitate a greater understanding of the effects of relative camber on the aerodynamic performance improvement of asymmetrical blunt trailing-edge modification. The mathematical expression of the blunt trailing-edge modification profile is established using the cubic spline function, and S812, S816 and S830 airfoils are modified to be asymmetrical blunt trailing-edge airfoils with different thicknesses. The prediction capabilities of two turbulence models, the k-ω SST model and the S-A model, are assessed. It is observed that the k-ω SST model predicts the lift and drag coefficients of S812 airfoil more accurately through comparison with experimental data. The best trailing-edge thickness and thickness distribution ratio are obtained by comparing the aerodynamic performance of the modifications with different trailing-edge thicknesses and distribution ratios. It is, furthermore, investigated that the aerodynamic performance of original airfoils and their modifications with the best thickness of 2% c and distribution ratio being 0:4 so as to analyze the increments of lift and drag coefficients and lift–drag ratio. Results indicate that with the increase of relative camber, there are relatively small differences in the lift coefficient increments of airfoils whose relative cambers are less than 1.81%, and the lift coefficient increment of airfoil with the relative camber more than 1.81% obviously decreases for the angle of attack less than 6.3°. The drag coefficient increment of S830 airfoil is higher than that of S816 airfoil, and those of these two airfoils mainly decrease with the angle of attack. The average lift–drag ratio increment of S816 airfoil with the relative camber of 1.81% at different angles of attack ranging from 0.1° to 20.2° is the largest, closely followed by S812 airfoil. The lift–drag ratio increment of S830 airfoil is negative as the angle of attack exceeds 0.1°. Thus, the airfoil with medium camber is more suited to the asymmetrical blunt trailing-edge modification.

A Lift-enhancing Mothed on Multielement Airfoil

Effects of Micro Blowing/suction Flow Control Devices on a NACA0015 Airfoil

Experimental and Numerical Studies on Aerodynamic Control of NACA 4418 Airfoil with a Rotating Cylinder

Optimization and Analysis of a Blown Flap Based on a Multielement Airfoil

Lift Enhancement for Airfoil at High Angle of Attack Using Flow-Induced Vibrations

Numerical investigation on the mechanism of micro tab to the airfoil

Aerodynamic characteristic of wind turbine with the leading edge slat and Microtab

Lift enhancement strategy and mechanism for a plunging airfoil based on vortex control

Aerodynamic Analysis and Optimization of Embedded Slot for Smooth Morphing Trailing Edge

Numerical study on technical and conceptual improvements to a civil aircraft trailing-edge flap using passive/active flow control

Effects of thickness and camber on aerodynamic performance of flapping wings during forward flight

The Design and Aerodynamic Analysis of Intelligent Variable Camber Airfoils with MFC

The Optimal Design of Civil Aircraft Winglet with Multiple Constraint

Numerical Simulation of 2D Airfoil Lift Enhancement with Flaps

CFD-based study of several geometrical parameters of winglet

Cfd Validation For High-Lift Devices: Three-Element Airfoil

An Inverse Design Method for Wing Shape Optimization Guided by Spanwise Lift Distribution

Aerodynamic Characteristics of Morphing Supercritical Airfoils for Aircraft with All-Stage High Performance

Aerodynamic Prediction of the High-Lift Common Research Model with Modified Turbulence Model

Parametric Research and Aerodynamic Performance Analysis of Wind Turbine Airfoil with Added Flap

Effect of Relative Camber on the Aerodynamic Performance Improvement of Asymmetrical Blunt Trailing-Edge Modification