Abstract:As a newly emerged active flow control technique, micro blowing/suction has shown a great potential in reducing the skin friction of turbulent flows. Throughout comprehensive analyses of active flow control of micro blowing/suction devices for a NACA0015 airfoil by means of CFD technique, the effects on various characteristics such as lift and drag coefficients and separation areas are investigated in this study. The control devices were placed at 12%c, 30%c and 70%c from the leading edge (c is the chord length of the airfoil), respectively. The corresponding trends of flow separation control at these locations were analyzed with a varied range of angle of attacks (AOA). The two- and three-dimensional incompressible unsteady detached-eddy simulation (DES) was used, along with the k-e turbulence model, in solving the flow problem. The numerical computational results have demonstrated that: (1) Installing micro blowing/suction devices near the separation point is more efficient, as blowing can mix the jet flow and the incoming flow to energize the turbulent kinetic energy and suction can mitigate the flow of low turbulent kinetic energy, which leads to a result of reducing the separation. (2) Suction sometime has more effective influence than blowing, when the flow control devices are placed at 12%c and 30%c. When the control device is placed at 70%c, the effects of lift enhancement and drag reduction are almost the same regardless of blowing and/or suction method. When the AOA is less than 18°, both methods can achieve the goal of lift enhancement and drag reduction. When the AOA is larger than 18°, neither blowing nor suction is efficient. (3) The 3-D numerical simulation shows that the vortex structure evolves from a 2-D pattern near the separation point to a 3-D pattern in the downstream. However the characteristics of flow separation control over a 3-D airfoil simulation agrees well with 2-D numerical results. (4) Blowing at 30%c can move the separation point downstream from 70%c to 80%c at AOA=11°.

Experimental and Numerical Studies on Aerodynamic Control of NACA 4418 Airfoil with a Rotating Cylinder

Numerical and Experimental Research of Flow Control on an NACA 0012 Airfoil by Local Vibration

Effects of Micro Blowing/suction Flow Control Devices on a NACA0015 Airfoil

Active control of circular cylinder flow by affiliated rotating cylinders

Aerodynamic shape optimization by continually moving ROM

Numerical Investigation of Active Flow Control on a Pitching NACA 0015 Airfoil Using Detached-eddy Simulation

A Study of Airfoil Parameterization, Modeling, and Optimization Based on the Computational Fluid Dynamics Method

Experimental Investigation of Lift Enhancement and Drag Reduction of Rotor Airfoil Using Co-flow Jet Concept

Effect of NACA0012 Airfoil Pitching Oscillation on Flow Past a Cylinder

Numerical Simulation of Circulation Control for a Wing Section Using Coanda Jets

Quantitative Study on the Flow Control of a 1:2 Rectangular Cylinder Based on the Leading-Edge Suction

Passive Flow Control of Dynamically Stalled Airfoil Using a Microcylinder

EXPERIMENTAL INVESTIGATION ON LIFT INCREMENT OF A PLASMA CIRCULATION CONTROL AIRFOIL

Pressure Distribution and Aerodynamics of Circular Cylinder with Freely Rotating Fairings

Laminar Wake Suppression of Airfoil by Rotating Rod at Low Reynolds Number

Numerical Simulation on Plasma Circulation Control Airfoil

Lift-Generation and Moving-Wall Flow Control over a Low Aspect Ratio Airfoil

Numerical Investigation on the Aerodynamic Performance of an Airfoil with Leading-Edge Protuberances

Numerical Study of the Lift Enhancement Mechanism of Circulation Control in Transonic Flow

Numerical Study of Improving Aerodynamic Performance of the Cylinder Airfoil of Magnus Wind Turbine

Noise Reduction by Feedback Rotary Oscillation of a Three-Dimensional Circular Cylinder