Abstract:In order to address the problem of CT saturation, a novel measurement‐protection‐integrated current transformer (MPICT) is proposed. To verify the feasibility and effectiveness of the MPICT, a series of theoretical analyses, 3D FEM simulations and laboratory tests are conducted. The simulation and experimental results indicate that the MPICT not only simultaneously satisfies the accuracy requirements in IEC 61,869‐2 for measuring CTs and protective CTs, but also has excellent DC tolerance capability. Current transformers (CTs) are widely used for energy metering, relay protection, condition monitoring and control circuits. However, CT saturation may lead to non‐negligible measurement errors and relay malfunctions, posing a threat to the stability and security of the power grid. In order to address the problem of CT saturation, a novel measurement‐protection‐integrated current transformer (MPICT) is proposed. First, the working states of the MPICT are summarised and the approximate expressions for the steady‐state measuring characteristics, the transient response characteristics, and the measurement errors are derived from the equivalent circuit model. Then, the feasibility of the MPICT and the theoretical analyses are verified by the 3D FEM simulation imitating the presented MPICT excited by diverse currents. Finally, a down‐scale prototype is fabricated and a series of tests are conducted in the laboratory to validate the effectiveness of the equipment. The simulation and experimental results suggest that the output of the MPICT can accurately reconstruct the primary current waveform, even if the primary current contains decaying or constant DC component.

Design of Data Fusion Based Electronic Current Transformer with Combined Structure

Design of ECT high speed data acquisition system for two-phase flow measurement

A New Dual-Modality Ect/Ert Technique Based On (Cd)-D-4 Principle

Quantifying Hidden Defect In Multi-Layered Structures By Using Eddy Current System Combined With A Scanner

Electronic Current Transformer Based on Low-power Current Transformer

A New Dual-Modality ECT/ERT Technique Based on C4D Principle

A Differential Compensated Air Coil Current Sensor for Switching Current Measurement of Power Devices.

The Development and Performance of Dual-Core DC Tolerant Current Transformer

A novel measurement‐protection‐integrated current transformer based on hybrid core and magnetic field sensor

A high accuracy current comparator with electronic compensation

The research and application on interfacing technology between Electronic Current Transformer and relay protection

Double Air-gap Current Transformer Applied to High Voltage Transmission Line On-site Mobile Comparison System

TheDesign Andimprovement Ofhighvoltage SideCircuit Inelectronic Current Transformer

A Novel Current Transformer Based on Virtual Air Gap and Its Basic Measuring Characteristics

Temperature Characteristic Analysis on Electronic Current Transformer

A Wide-Bandwidth Inexpensive Current Sensor Based on the Signal Fusion of Tunneling Magnetoresistance and a Current Transformer

Analysis of ECT effect on accuracy of measurement and protection

Design and Hardware Experiment of Concentrating Magnetic Ring of Current Sensors Used in Open-Loop Fluxgate

An Assistant Criterion for Distinguishing Current Transformer Saturation Based on the Load Current Detection

Design of novel structure current transformer with shielding coils for overcoming the saturation of core

Inspection of defects in conductive multi-layered structures by an eddy current scanning technique: Simulation and experiments