Abstract:In a variable speed drive (VSD) system, high-frequency switching of power devices will cause large common-mode (CM) voltage during operation. While the CM voltage acts on the parasitic capacitance of the system, it will generate serious CM current on the motor side. It is necessary to model the VSD system so as to analyze and forecast the CM current theoretically. However, an essential condition of modeling CM current is to extract the CM impedance on the motor side of the system. In this paper, a novel extraction method for the CM impedance of an inverter-fed induction motor is proposed. First of all, time-domain waveforms of the CM voltage and current on the motor side of the VSD system are measured, and then mathematical calculations are performed to obtain the spectrum characteristics of the CM impedance on the motor side of the system. Compared to the traditional extraction methods of the impedance parameter by an impedance measurement or numerical calculation, the method proposed in this paper does not require laborious modeling of the motor or cable, and the extraction process is much simpler and easier. Moreover, in traditional methods, the motor impedance parameters are usually obtained in a nonworking state, while the proposed extraction method can be conducted in working state. Thus, the CM impedance extracted by the proposed method will be more accurate. Through comparing measurement and the simulation results of the CM current on motor side, the proposed CM impedance extraction method for an inverter-fed induction motor is validated.

Analysis of CM Volt-Second Influence on CM Inductor Saturation and Design for Input EMI Filters in Three-Phase DC-Fed Motor Drive Systems

Elimination of Common-Mode Choke Saturation Caused by Self-Resonance of the EMI Filter in a Variable-Frequency Drive System

Current Control Scheme for LC-Equipped PMSM Drive Considering Decoupling and Resonance Suppression in Synchronous Complex-Vector Frame

FEM Analysis and Application of Saturation Effect PMLSM Winding Inductance

Extraction of Common-Mode Impedance of an Inverter-Fed Induction Motor

A study of motor-end EMI filter on output common-mode noise suppression in DC-fed motor drive system

A Systematic Design and Optimization Technique for the Suppression of EMI Common Mode (CM) Noise

Common-Mode Resonance Suppression Strategy in High-Speed Compressor Drive

Modeling of Common-Mode Impedance of an Inverter-Fed Induction Motor from Online Measurement

Saturation Effect Analysis and Dynamic Inductance Calculation of Common Mode Choke

Analysis and Design of Passive Damping for LC-Equipped Permanent-Magnet Synchronous Machine Drive System

Analysis and Suppression of Common-Mode Voltage in Open-End Winding Induction Motor Drive System Fed by Dual Inverter

Experimental analysis and simulation of saturation effects in interior permanent-magnet synchronous motor

Influence of Motor Cable on Common-Mode Currents in an Inverter-Fed Motor Drive System

Impact of reduced common mode voltage PWM and common mode inductor on EMI characteristics of an inverter-driven motor

Analysis and Suppression of Common Mode Voltage for Motor Drive in EV

FEA-Based Mathematical Modeling and Simulation for IPMSM Drive with Consideration of Saturation and Cross-Coupling Influence

Integrated filtering choke for SMPS with enhanced EMI noise suppression performance

A Multi-Function Common Mode Choke Based on Active CM EMI Filters for AC/DC Power Converters

A Fully Integrated CM Choke with Improved DM Noise Attenuation

Design of Active EMI Filters with the Integrated Passive Component