Abstract:As a newly emerged active flow control technique, micro blowing/suction has shown a great potential in reducing the skin friction of turbulent flows. Throughout comprehensive analyses of active flow control of micro blowing/suction devices for a NACA0015 airfoil by means of CFD technique, the effects on various characteristics such as lift and drag coefficients and separation areas are investigated in this study. The control devices were placed at 12%c, 30%c and 70%c from the leading edge (c is the chord length of the airfoil), respectively. The corresponding trends of flow separation control at these locations were analyzed with a varied range of angle of attacks (AOA). The two- and three-dimensional incompressible unsteady detached-eddy simulation (DES) was used, along with the k-e turbulence model, in solving the flow problem. The numerical computational results have demonstrated that: (1) Installing micro blowing/suction devices near the separation point is more efficient, as blowing can mix the jet flow and the incoming flow to energize the turbulent kinetic energy and suction can mitigate the flow of low turbulent kinetic energy, which leads to a result of reducing the separation. (2) Suction sometime has more effective influence than blowing, when the flow control devices are placed at 12%c and 30%c. When the control device is placed at 70%c, the effects of lift enhancement and drag reduction are almost the same regardless of blowing and/or suction method. When the AOA is less than 18°, both methods can achieve the goal of lift enhancement and drag reduction. When the AOA is larger than 18°, neither blowing nor suction is efficient. (3) The 3-D numerical simulation shows that the vortex structure evolves from a 2-D pattern near the separation point to a 3-D pattern in the downstream. However the characteristics of flow separation control over a 3-D airfoil simulation agrees well with 2-D numerical results. (4) Blowing at 30%c can move the separation point downstream from 70%c to 80%c at AOA=11°.

Numerical Investigation on Separation Control for Flow over a Bump with Synthetic Jet

Numerical simulation research of high altitude reverse jet flow for stage separation of missile

Numerical Simulation of the Performance of the Sc-89 Jet Impact System

Effects of Micro Blowing/suction Flow Control Devices on a NACA0015 Airfoil

Numerical Study of Active Shock Control for Transonic Aerodynamics

Numerical Investigations of Separation Control of a Hump Model with Steady Suction and Injection

Numerical Investigation on Controlling Separated Cascade Flows by Using Jets

Control of Unsteady Separated Flows Inside Axial Compressors by Synthetic Jets

NUMERICAL STUDIES ABOUT ACTIVE FLOW CONTROL OVER A HUMP FLOW

Investigation of Practical Flow Control Methodologies with RANS/LES Hybrid Methods

Control of flow separation over a circular cylinder using synthetic jet

Numerical simulation of unsteady characteristics of large flow rate jet interference

Numerical simulation of separation flow in the hydraulic turbomachinery impeller passage

Numerical simulation investigation on the suction stroke and blowing stroke of synthetic jet circulation control

Numerical study of flow separation control over a circular hump using synthetic jet actuators

Separation flow control and engineering application of synthetic jets in compressor

Numerical investigation of vented plume into a supersonic flow in the early stage of rocket hot separation

Influences of microjet pressure and number of microjets on the control of shock wave/boundary layer interaction

Numerical study of passive and active flow separation control over a NACA0012 airfoil

A combined experimental and numerical study on aerodynamic load reduction for a swept wing by using jets

Numerical Simulation Study of Energy Separation in Jet Shear Layer