Abstract:As a newly emerged active flow control technique, micro blowing/suction has shown a great potential in reducing the skin friction of turbulent flows. Throughout comprehensive analyses of active flow control of micro blowing/suction devices for a NACA0015 airfoil by means of CFD technique, the effects on various characteristics such as lift and drag coefficients and separation areas are investigated in this study. The control devices were placed at 12%c, 30%c and 70%c from the leading edge (c is the chord length of the airfoil), respectively. The corresponding trends of flow separation control at these locations were analyzed with a varied range of angle of attacks (AOA). The two- and three-dimensional incompressible unsteady detached-eddy simulation (DES) was used, along with the k-e turbulence model, in solving the flow problem. The numerical computational results have demonstrated that: (1) Installing micro blowing/suction devices near the separation point is more efficient, as blowing can mix the jet flow and the incoming flow to energize the turbulent kinetic energy and suction can mitigate the flow of low turbulent kinetic energy, which leads to a result of reducing the separation. (2) Suction sometime has more effective influence than blowing, when the flow control devices are placed at 12%c and 30%c. When the control device is placed at 70%c, the effects of lift enhancement and drag reduction are almost the same regardless of blowing and/or suction method. When the AOA is less than 18°, both methods can achieve the goal of lift enhancement and drag reduction. When the AOA is larger than 18°, neither blowing nor suction is efficient. (3) The 3-D numerical simulation shows that the vortex structure evolves from a 2-D pattern near the separation point to a 3-D pattern in the downstream. However the characteristics of flow separation control over a 3-D airfoil simulation agrees well with 2-D numerical results. (4) Blowing at 30%c can move the separation point downstream from 70%c to 80%c at AOA=11°.

NUMERICAL STUDIES ABOUT ACTIVE FLOW CONTROL OVER A HUMP FLOW

Numerical Investigations of Separation Control of a Hump Model with Steady Suction and Injection

ACTIVE FLOW CONTROL APPLICATIONS WITH ZERO NET MASS FLUX ACTUATOR IN FLOW FIELD OF SUPERSONIC INLET

Numerical Study of Heat Flux Reduction Mechanism of the Counterflowing Jet in Rarefied Flows

Effects of Micro Blowing/suction Flow Control Devices on a NACA0015 Airfoil

Numerical Analysis Of Active Flow Control Around Airfoil By Synthetic Jet Technology In Low Reynolds Number

Quantitative Study on the Flow Control of a 1:2 Rectangular Cylinder Based on the Leading-Edge Suction

Numerical Investigation on Controlling Separated Cascade Flows by Using Jets

Investigation of Practical Flow Control Methodologies with RANS/LES Hybrid Methods

Numerical study of passive and active flow separation control over a NACA0012 airfoil

NUMERICAL SIMULATION OF LAMINAR SQUARE IMPINGING JET FLOWS

Numerical Investigation on Application of Boundary Layer Suction to Control the Flow Separations

Numerical study of flow separation control over a circular hump using synthetic jet actuators

Numerical Study of Active Flow Control over a Hypersonic Backward-Facing Step Using Supersonic Jet in Near Space

NUMERICAL INVESTIGATION OF CONFINED SINGLE JET IMPINGING ON A DIMPLED TARGET SURFACE USING Al2O3-WATER NANOFLUIDS

Numerical Simulations of Hybrid Laminar Flow Control by Suction over an Airfoil

Numerical Investigation of Active Flow Control on a Pitching NACA 0015 Airfoil Using Detached-eddy Simulation

Numerical simulation of unsteady characteristics of large flow rate jet interference

Numerical study on flow separation control of cascades with synthetic jet using dynamic mesh method

Numerical and Experimental Investigation of the Influence of Backpressure on a Confined Impinging Jet for Small Nozzle-to-plate Spacing

Experimental and numerical investigations on flow field characteristics of pintle injector