Abstract:This study conducted Detached-Eddy Simulations (DES) of actively controlled flow over a 0.35 m chord NACA0015 airfoil at an incidence angle of 11° and a chord Reynolds number of 1 million. The uncontrolled, natural flow were simulated by using DES-type methods, with a comparison of different underlying RANS models and subgrid-scale stress models in LES mode. Results from these computations were compared with experimental observations, enabling their reliable assessment through the detailed investigation of the Reynolds stresses as well as the separation and reattachment. It was found that among all five DES-type methods, only the Spalart–Allmaras-based Improved Delayed DES (IDDES-SA) captured the separation point as measured in the experiments. The classical vortex-shedding and the shear-layer flapping modes for airfoil flows with shallow separation were also extracted from the IDDES-SA results by using Dynamic Mode Decomposition. With better understanding of unsteady flow features, effective control practices were illustrated. The pulsed blowing actuation was adopted according to the experimental settings. The flow-field around jet orifices was resolved, instead of the use of actuation boundary conditions. It was found that for all actuation frequencies investigated in this article, the saturation of lift-to-drag ratio was yielded already at intermediate momentum coefficients, two-fifths of the actuation amplitude used in the experiment; the optimal actuation frequency was 0.6 among all cases, consistent with the dominant frequency of the baseline flow. The suppression of separation bubble led to a maximum lift-to-drag ratio enhancement of 194%, as well as a sharp decrease of all Reynolds stress components. To further reduce the strong unsteadiness introduced by excitation, a phase shift among jet orifices was applied and evaluated. The pulsed blowing with the jet orifices in an anti-phased manner was found to be very effective to damp the fluctuations of the lift around its mean value, though it led to a small decrease in mean lift.

A combined experimental and numerical study on aerodynamic load reduction for a swept wing by using jets

Lift Augmentation Potential of the Circulation Control Wing Driven by Sweeping Jets

Effects of Micro Blowing/suction Flow Control Devices on a NACA0015 Airfoil

Numerical Study of Active Shock Control for Transonic Aerodynamics

Effects of blowing and suction jets on the aerodynamic performance of wind turbine airfoil

Numerical Analysis Of Active Flow Control Around Airfoil By Synthetic Jet Technology In Low Reynolds Number

Design exploration on the drag reduction and thermal protection over a blunted waverider with multiple opposing jets

Detached-eddy Simulation of Flow Past a Pitching NACA 0015 Airfoil with Pulsed Actuation

Computational Study of Drag Reduction at Various Freestream Flows Using A Counterflow Jet from A Hemispherical Cylinder

Numerical Study of Flow Control to Increase Vertical Tail Effectiveness of an Aircraft by Tangential Blowing

Sweeping jet control of flow around a circular cylinder

Comparative study of two combined blowing and suction flow control methods on pitching airfoils

Numerical Study of Interaction Between Jet with Rudders on Slender Body at Hypersonic Condition

Learning Active Flow Control Strategies of a Swept Wing by Intelligent Wind Tunnel

Enhancement of aerodynamic performance of a heaving airfoil using synthetic-jet based active flow control

Fluidic Flow Control Devices for Gust Load Alleviation

Numerical simulation investigation on the suction stroke and blowing stroke of synthetic jet circulation control

Effectiveness of multiple jets for a finned large slenderness ratio missile in supersonic crossflows

Laminar vortex dynamics around forward-swept wings

Numerical Simulation of Circulation Control for a Wing Section Using Coanda Jets

A Numerical Study on the Flap Side-Edge Noise Reduction Using Passive Blowing Air Concept