Abstract:Solution-driven metal-oxide semiconductors have recently received much attention as a viable option for low-cost, flexible electronic devices. In this paper, a simple, environmentally friendly aqueous solution method has been adopted to deposit an ultrathin In2O3 semiconductor layer with a thickness of about 7 nm at low temperature. Then, in combination with the advantages of atomic layer deposition (ALD) technology, an ultrathin aluminum oxide dielectric layer of about 20 nm was prepared to fabricate high-performance In2O3/Al2O3 thin-film transistor (TFT) devices. The device with optimized annealing temperature of 280 degrees C has demonstrated an excellent electrical performance, including a high saturation mobility of 11.85 cm(2) .V-1 . s(-1), a large ON/OFF current ratio of 10(6), a low threshold voltage of 0.12 V, a small hysteresis voltage of 0.05 V, and a small density of interface state of 1.97 x 10(12) cm(-2), respectively. To demonstrate the potential of In2O3/AlOx TFT toward more complex logic applications, the unipolar inverter was further constructed and exhibited a high gain of 5. Importantly, all these device parameters were obtained at an ultralow operating voltage of 2.5 V. As a result, it can be inferred that the water-induced In2O3 TFTs based on ALD-derived Al2O3 dielectrics have a potential application as a promising alternative for lowcost, low-power consumption, and large-area environmentally friendly oxide flexible electronics.

Dry Etching of Thick Aluminum Film for Q-improvement of Spiral Inductors on Silicon

Eco-Friendly, Water-Induced In2O3 Thin Films for High-Performance Thin-Film Transistors and Inverters

A Novel Local-Dielectric-Thickening Technique for Performance Improvements of Spiral Inductors on Si Substrates

Modelling On-Chip Circular Double-Spiral Stacked Inductors for RFICs

A High-Efficiency and Energy-Saving Method for Purifying Industrial Silicon for Silicone Use

Experimental Characterisation Of On-Chip Octagonal Double-Helix Inductors On Silicon Substrates

Backside Growth Thick Porous Silicon Layers for High Q On-Chip Rf Integrated Inductors

A Dual-Purpose Method to Enhance Heat Transfer and Prevent Notching Effect in Deep Reactive Ion Etching

Simulation and Optimization of High Performance On-Chip Solenoid MEMS Inductor

Physical Models of Planar Spiral Inductor Integrated on the High-Resistivity and Trap-Rich Silicon-on-Insulator Substrates

High Q-factor CMOS-MEMS inductor

Novel On-Chip Spiral Inductors with Back Hollow Structure

The Enhancement Of Q-Factor Of Planar Spiral Inductor With Low-Temperature Annealing

Enhancement of quality factor in RF-MEMS spiral inductors by etching out substrate

CMOS-compatible micromachining techniques for fabricating high-performance edge-suspended RF/microwave passive components on silicon substrates

Improved Subthreshold Characteristics of Epi-Silicon FinFET via Fin Surface Passivation Technologies

High-Q CMOS-compatible micromachined edge-suspended spiral inductors

P‐40: TFT‐LCD a‐Si Wet Etch Technology

Wafer level bulk titanium ICP etching using SU8 as an etching mask

High-Q Integrated Inductor Using Post-Cmos Selectively Grown Porous Silicon (sgps) Technique for Rfic Applications

An improved method to remove anti-footing Al layer after DRIE