Abstract:<math>{101¯2}</math> twins were introduced into the magnesium (Mg) plate AZ31 via pre-rolling along its transverse direction. The plates, both with and without the pre-induced <math>{101¯2}</math> twins, were subjected to uniaxial tension along different directions. Using crystal plasticity modeling, we found that the strengthening effect of the pre-induced <math>{101¯2}</math> twins on the macroscopic flow stress primarily arised from the increased slip resistance caused by the boundaries, rather than the orientation hardening due to the twinning reorientation (although the latter did make its contribution in some specific loading directions). Besides, the pre-existing <math>{101¯2}</math> twins were found, by both experiments and simulation, to promote the activity of prismatic 〈a〉 and pyramidal 〈c + a〉 in the parent matrix of the material. Further analysis showed that the enhanced non-basal slip activity is related to the <math>{101¯2}</math> twin boundaries' low micro Hall-Petch slope ratios of non-basal slips to basal slip. With the critical resolved shear stress (CRSS) obtained from crystal plasticity modeling and the orientation data from EBSD, a probability-based slip transfer model was proposed. The model predicts higher slip transfer probabilities and thus lower strain concentration tendencies at <math>{101¯2}</math> twin boundaries than that at grain boundaries, which agrees with the experimental observation that the strain localization was primarily associated with the latter. The present findings are helpful scientifically, in deepening our understanding of how the pre-induced <math>{101¯2}</math> twins affect the strength and slip activity of Mg alloys, and technologically, in guiding the design of the pre-strain protocol of Mg alloys.

Atomic Motion in Mg–3Al–1Zn During Twinning Deformation

The Effect of Twin–twin Interaction in Mg 3al 1zn Alloy During Compression

EBSD Analysis and Theoretical Prediction of Twin Orientations During Compression in Mg-3Al-1Zn

Twinning Behaviour in the Intermetallic Compound Al 18 Cr 2 Mg 3

{ 10 1 ̄ 2 } twin–twin intersection-induced lattice rotation and dynamic recrystallization in Mg–6Al–3Sn–2Zn alloy

Identification and Analysis of Twinning Variants During Compression of a Mg–Al–Zn Alloy

Twinning Behavior in a Rolled Mg-Al-Zn Alloy under Dynamic Impact Loading

Understanding the interaction of {10-12} twins and Mg17Al12 precipitates in magnesium alloys via high-resolution electron microscopy

Atomistic Insight into Three-Dimensional Twin Embryo Growth in Mg Alloys

Atomic Shuffling Dominated Mechanism for Deformation Twinning in Magnesium

Understanding the Interaction of {10–12} Twins and Mg17Al12 Precipitates in Magnesium Alloys Via High-Resolution Electron Microscopy

Onset of Detwinning in Mg-3Al-1Zn Alloy: A Synchrotron-Based X-ray Diffraction Study

Deformation Twinning Mechanism in Hexagonal-Close-packed Crystals

A Study of {10-12} Twinning Activity Associated with Stress State in Mg-3Al-1Zn Alloy during Compression

A nucleation mechanism of deformation twins in pure aluminum

Deformation Twinning in Hexagonal Close-Packed Single Crystals under Uniaxial Compression

Three-dimensional study of grain scale tensile twinning activity in Mg: A combination of microstructure characterization and mechanical modeling

Twinning-mediated Plasticity by a Novel Multistage Twinning Mode in an Mg-Al-Gd Alloy

Twinning-induced plasticity with multiple twinning modes and disclinations in Mg alloys

Twin-twin Geometric Structure Effect on the Twinning Behavior of an Mg-4Y-3Nd-2Sm-0.5Zr Alloy Traced by Quasi-in-situ EBSD

On the strengthening and slip activity of Mg-3Al-1Zn alloy with pre-induced { 10 1 ̄ 2 } twins