Abstract:Magnesium alloys were used widely in automotive, communication, electronic and aerial industries, but their mechanical properties at ambient and elevated temperatures should be enhanced further. Microstructures and phase compositions of as-cast ZK60-xLa (x=0~3) magnesium alloys were analyzed by optical microscope, scanning electron microscope, X-ray diffraction and differential scanning calorimetry. Meanwhile, the hardness and tensile mechanical property were tested. The results showed that as-cast microstructure was refined gradually with increasing the La content. MgZn 2 phase with low melting point gradually decreased to disappear, while τ 1-Mg 42Zn 53La 5 new phase with high melting point increased gradually. Meanwhile, second phase was inclined to distribute along grain boundary by continuous reticulation. Hardness HV exhibited peak values at low and high La contents, respectively. With increasing the La content, tensile strength σ b and elongation δ at ambient temperature decreased gradually from 225 MPa and 9% for ZK60 alloy to 137 MPa and 1.5% for ZK60-3.04La alloy, respectively. Tensile fracture changed from the complex mode of ductile fracture and brittle fracture to single brittle fracture. However, the addition of La could enhance the tensile mechanical property at elevated temperature effectively. At ambient temperature, ZK60-1.03La alloy exhibited lower value of σ b by 25 MPa than ZK60 alloy. At 423 K, σ b was reduced to 181 and 174 MPa for ZK60-1.03La and ZK60 alloys, respectively, which led to higher value of σ b by 7 MPa for the former alloy. At 448 K, σ b was further reduced to 168 and 150 MPa for the two alloys, respectively, where the gap reached 18 MPa. Only τ 1-Mg 42Zn 53La 5 phase with high thermal stability existed among the microstructure of ZK60-1.03La alloy, which could pin the grain boundary and hinder its sliding at elevated temperature effectively.

Microstructures and Mechanical Properties of As-Cast AZ91+0-2.0wt.%La Magnesium Alloys

Effect of La on microstructure and properties of AZ61 magnesium alloy

Effects of La and Nd Co-addition on microstructure and mechanical properties of as-cast AZ91 magnesium alloy

The Evolution of Microstructure, Mechanical Properties and Fracture Behavior with Increasing Lanthanum Content in AZ91 Alloy

Effects of La on As-Cast Microstructure and Mechanical Property of ZK60 Alloy

Effect of La Addition on Microstructure, Mechanical Behavior, Strengthening and Toughening Mechanisms of Cast Mg-Gd-Zn Alloy

Effect of La and Nd on Microstructures and Mechanical Properties of AZ61 Wrought Magnesium Alloy

Effects of La Addition on the Microstructure, Thermal Conductivity and Mechanical Properties of Mg-3Al-0.3Mn Alloys

Effect of La on the Mechanical Property and Corrosion Resistance of Az91d Magnisum Alloy

The Microstructure and Mechanical Properties of As-cast Mg-10Gd-3Y-xZn-0.6Zr (x=0, 0.5, 1 and 2 Wt%) Alloys

The investigation on microstructure evolution and mechanical behavior of extruded Mg-1.5Al-xLa-Mn (x=0.5, 1, 2wt%) alloys

The Microstructure and Mechanical Properties of As-Extruded Ca-containing Mg–6Zn–3La Alloys

Effect of La Addition on the Microstructure and Mechanical Properties of Mg–6 Wt% Zn Alloys

Effects of La addition on the mechanical properties and thermal-resistant properties of Al–Mg–Si–Zr alloys based on AA 6201

Modification of Microstructure and Mechanical Properties of Extruded AZ91-0.4Ce Magnesium Alloy Through Addition of Ca

Microstructure and Mechanical Properties of Mg 14li 1al 0.3la Alloys Produced by Two-Pass Extrusion

Effect of La Content on Microstructure, Thermal Conductivity and Mechanical Properties of Mg–4Al Magnesium Alloys

Microstructures and Mechanical Properties of Al-Cu-Mg-(Ag, La) Alloys

Microstructure investigation and first-principle analysis of die-cast AZ91 alloy with calcium addition

Comparative Study on the Microstructure and Mechanical Properties of Mg-Li-Al Based Alloys with Yttrium and Strontium Addition

Enhancing Mechanical Properties of Mg-Gd-Y-Zn Alloys Via Microalloying with Ce and La