Abstract:This study deals with the mechanical and visco-elastic behaviour of Flexible thermoplastic polyolefin (FTO) with different amount of halogen-free flame retardants. In this work, polypropylene and propylenebased elastomer were compounded with two types of magnesium hydroxide (MDH) at different loading. The crystalline structure of the MDH was characterized by X-ray diffraction. Scanning electron microscopy was used to determine particle size of MDH used in the polymer composite and phase morphology. Mechanical properties as tensile yield stress and flexural modulus of polymer composites were measured. The influence of particle size, concentration and morphology of filler MDH on the viscoelastic behaviour of the prepared composites were studied. INTRODUCTION Flexible thermoplastic polyolefin mixture is of a polypropylene (PP) or a polyethylene (PE) with an elastomer, such as, ethylenepropylene rubber (EPR), ethylenepropylene-diene rubber (EPDM). [1–3] While the polypropylene provides tensile strength and increased heat resistance, the elastomer provides flexibility, extensibility and good self-hot tack. Since it is well known that FTO are a highly combustible materials, it is usually highly desirable to improve its flame retardancy and reduce the emissions of smoke and poisonous gases.[4,5] To achieve the required flame retardant grade of low smoke and non-toxic character, metal hydroxides, e.g. MDH, could be added (generally in high filling amount, up to 60% mass fraction). However, high filler loading leads always without exception to a deterioration of the mechanical and visco-elastic performances in the composites. [6–8] The main goal of the work reported in this paper was to characterise mechanical properties of pressed flexible thermoplastic polyolefin sheets filled with different amount of magnesium hydroxide (FTO/MDH). Beside this, the visco-elastic behaviour of prepared composite systems was evaluated with respect to particle sizes, concentrations and morphologies of utilised fillers.

Deformation and fracture of Mg(OH)2-filled polyolefin composites under tensile stress

Fracture behavior and deformation mechanism of polypropylene/ethylene-octene copolymer/magnesium hydroxide ternary phase composites

Polyolefin Composites Filled with Magnesium Hydroxide

A Molecular Study on the Reinforcement of Polymethylene Elastomers

Influence of Interfacial Adhesion on Stress-Strain Properties of Highly Filled Polyethylene

Tensile Deformation and Fracture Mechanism of Highly Filled High‐density Polyethylene/al(oh)3 Composites

Studies of the Toughness and Reinforcement of PP/Magnesium Hydrate Whisker/POE Composites

Polyethylene/maleic Anhydride Grafted Polyethylene/organic‐montmorillonite Nanocomposites. I. Preparation, Microstructure, and Mechanical Properties

Deformation and Molecular Orientation in Films of Metallocene Polypropylene, Ethylene-Butylene Rubber, and Their 80/20 (W/W) Blend Revealed by the Simultaneous Kinetic Measurement of Microscopic Infrared Dichroism, Macroscopic Stress, and Mesoscale Strain

Morphology and Properties of Linear Low-Density Polyethylene Highly Loaded with Aluminum Hydroxide

Effect of Silicone Oil on the Mechanical Properties of Highly Filled Hdpe Composites

The Influence of Magnesium Hydroxide Morphology on the Mechanical and Visco-elastic Properties of Flexible Thermoplastic Polyolefin

Tensile properties and stress whitening of polypropylene/polyolefin elastomer/magnesium hydroxide flame retardant composites for cable insulating application

Tensile Deformation Mechanisms of Polypropylene/elastomer Blends Reinforced with Short Glass Fiber

PP/elastomer/calcium carbonate composites: effect of elastomer and calcium carbonate contents on the deformation and impact behavior

Preparation of EP-toughed Mg(OH)2 flame retarded polyethylenes Wang

Plastic damage mechanisms of polypropylene/polyamide 6/polyethelene-octene elastomer blends under cyclic tension

Toughness Mechanism of Polypropylene/elastomer/filler Composites

Effects of silicone oil and polymeric modifiers on the mechanical properties of highly filled LLDPE

Thermal Degradation of Flame‐retarded Polyethylene/magnesium Hydroxide/poly(ethylene‐co‐propylene) Elastomer Composites

Mechanical Properties and Volume Dilatation of HDPE/CaCO3 Blends with and Without Impact Modifier