The Influence of Magnesium Hydroxide Morphology on the Mechanical and Visco-elastic Properties of Flexible Thermoplastic Polyolefin

Abstract:This study deals with the mechanical and visco-elastic behaviour of Flexible thermoplastic polyolefin (FTO) with different amount of halogen-free flame retardants. In this work, polypropylene and propylenebased elastomer were compounded with two types of magnesium hydroxide (MDH) at different loading. The crystalline structure of the MDH was characterized by X-ray diffraction. Scanning electron microscopy was used to determine particle size of MDH used in the polymer composite and phase morphology. Mechanical properties as tensile yield stress and flexural modulus of polymer composites were measured. The influence of particle size, concentration and morphology of filler MDH on the viscoelastic behaviour of the prepared composites were studied. INTRODUCTION Flexible thermoplastic polyolefin mixture is of a polypropylene (PP) or a polyethylene (PE) with an elastomer, such as, ethylenepropylene rubber (EPR), ethylenepropylene-diene rubber (EPDM). [1–3] While the polypropylene provides tensile strength and increased heat resistance, the elastomer provides flexibility, extensibility and good self-hot tack. Since it is well known that FTO are a highly combustible materials, it is usually highly desirable to improve its flame retardancy and reduce the emissions of smoke and poisonous gases.[4,5] To achieve the required flame retardant grade of low smoke and non-toxic character, metal hydroxides, e.g. MDH, could be added (generally in high filling amount, up to 60% mass fraction). However, high filler loading leads always without exception to a deterioration of the mechanical and visco-elastic performances in the composites. [6–8] The main goal of the work reported in this paper was to characterise mechanical properties of pressed flexible thermoplastic polyolefin sheets filled with different amount of magnesium hydroxide (FTO/MDH). Beside this, the visco-elastic behaviour of prepared composite systems was evaluated with respect to particle sizes, concentrations and morphologies of utilised fillers.

Materials Science,Engineering