Abstract:A thermoplastic vulcanizate (TPV) of a ethylene-propylene-diene terpolymer (EPDM) and nylon copolymer (PA) was prepared by dynamic vulcanization. Maleic anhydride (MAH)-grafted EPDM (EPDM-g-MAH), MAH-grafted EPR (EPR-g-MAH), and chlorinated polyethylene (CPE) were used as compatibilizers. The effect of dynamic vulcanization and compatibilizer on the crystallization behavior of PA was investigated. Differential scanning calorimeter measurement results showed no pronounced shift in the crystallization temperature for PA in EPDM-PA TPV compared to that for PA in the neat state, whereas the crystallization temperature increased after adding compatibilizer. The decrease in the crystallinity of TPVs was a result of the crystallization occurring in confined spaces between rubber particles. The equilibrium melting temperature (Tm-0) of the PA copolymer was measured and was determined to be 157degreesC. The isothermal crystallization kinetics of PA in the neat and TPV states also was investigated. The crystallization rate was highest in the compatibilized TPV and lowest in the neat PA, whereas it was intermediate in the uncompatibilized TPV unvulcanized blends. Compared with unvulcanized EPDM-PA blends, the dynamic vulcanization process seemed to cause an obvious increase in the crystallization rate of the PA copolymer, especially when a suitable compatibilizer was used. This occurred because the dynamic vulcanization introduced fine crosslinked rubber particles that could act as heterogeneous nucleating centers. In addition, the use of a suitable compatibilizer permitted the formation of finely dispersed vulcanized rubber particles and therefore increased the density of the nucleating centers. The complex morphology of the blends was investigated by atomic force microscopy to evaluate the effect of compatibilizer on the size of the dispersed rubber particles. Compared with the morphology of TPVs with the same dosage of EPDM-g-MAH compatibilizer, the morphology of TPVs using EPR-g-MAH as compatibilizer showed much smaller dispersed rubber particles, which may have contributed to the higher crystallization rate. (C) 2003 Wiley Periodicals, Inc.

Preparation and Flammability of Epdm/Pp/Mg(Oh)(2) Dynamic Vulcanizates

Study on EPDM/PP TPV

Properties of intumescent flame retardant ethylene propylene diene monomer/polypropylene thermoplastic vulcanizate

Study of the Addition of a Thermoplastic Vulcanizate to a HDPE Composite Highly Filled with Magnesium Hydroxide and Its Effect on the Tensile and Flame Retardant Properties

Study on flame retardance of EPDM/PP TPV

Thermal Degradation of Flame‐retarded Polyethylene/magnesium Hydroxide/poly(ethylene‐co‐propylene) Elastomer Composites

PP/EPDM-based Dynamically Vulcanized Thermoplastic Olefin with Zinc Dimethacrylate: Preparation, Rheology, Morphology, Crystallization and Mechanical Properties

In Situ Reactive Compatibilization and Reinforcement of Peroxide Dynamically Vulcanized Polypropylene/ethylene‐propylene‐diene Monomer Tpv by Zinc Dimethacrylate

Preparation and characterization of ethylene–vinyl acetate copolymer (EVA)–magnesium hydroxide (MH)–hexaphenoxycyclotriphosphazene (HPCTP) composite flame-retardant materials

Influence of Maleic Anhydride Grafted Ethylene-Vinyl Acetate Copolymer as a Compatibilizer on Combustion and Thermal Stability Properties of Magnesium Hydroxide Flame-Retardant Ethylene Propylene Diene Terpolymer Composites

Effects of poly(ethylene-co-propylene) elastomer on mechanical properties and combustion behaviour of flame retarded polyethylene/magnesium hydroxide composites

Flammability Performance of Intumescent Flame Retardant EPDM/PP-Based Thermoplastic Elastomers

Investigation of crystallization behavior in dynamically vulcanized EPDM-nylon copolymer blends

A Study of the Novel Intumescent Flame‐retarded PP/EPDM Copolymer Blends

The Effect of Lanthanum Trimethacrylate on the Mechanical Properties and Flame Retardancy of Dynamically Vulcanized PP/EPDM Thermoplastic Vulcanizates

Epdm/Polyamide Tpv Compatibilized by Chlorinated Polyethylene

PP/POE thermoplastic elastomer prepared by dynamic vulcanization and its flame retardant modification

Effect of Additives on the Morphology Evolution of EPDM/PP TPVs During Dynamic Vulcanization in a Twin-Screw Extruder

Exploration of the Fire-Retardant Potential of Microencapsulated Ammonium Polyphosphate in Epoxy Vitrimer Containing Dynamic Disulfide Bonds

Mechanical properties, morphological structure, and thermal behavior of dynamically photocrosslinked PP/EPDM blends

Study on the Properties of Ethylene‐vinyl Acetate Rubber Vulcanizate Filled with Superfluous Magnesium Hydroxide/methacrylic Acid