Abstract:Fragmentation experiments of quartzite particles were carried out in a laboratory-scale hot fluidized bed. The influences of the factors, the initial particle size (2.5–6 mm) and the bed temperature (650–950 °C), on the fragmentation were investigated. The experimental results indicate that both the fragmentation ratio (Nf) and the fragmentation index (Sf) curves show a nearly linearly increase with the initial particle size from 2.5 to 6 mm or with the bed temperature from 650 to 950 °C. The changing ratio of size (Fd) is relatively invariant with the initial particle size at all considered bed temperatures except the initial particle size of 5–6 mm at which Fd shows a more intense reduction at a higher bed temperature as a whole. The extent of the fragmentation is quite limited when the bed temperature is lower than 750 °C and the initial particle size is smaller than 3 mm. The analysis of the quartzite particles size distribution after fragmentation shows that it is the compressive and thermally induced stresses within the outer region of the particle that causes the particle to fracture with many small fragments on the particle surface. Finally, based on the grey theory, a grey forecasting model GM(1, 3) is developed to predict the thermal fragmentation of the quartzite particles. The comparison demonstrates that the forecasted values are in good agreement with the experimental data, and the average residual error is lower than 7.13%. Using the model GM(1, 3), the critical fragmentation diameter (dc) under different bed temperatures is forecasted.

A model on attrition of quartzite particles as a bed material in fluidized beds

Mathematic Model of Attrition of Quartzite Particles As Medium Material in Fluidized Bed

CFD Simulation of an Agitated Gas-Fluidized Bed: Effects of Particle–particle Restitution Coefficient on the Hydrodynamics

Attrition experiment and gray relational analysis of quartzite particles as medium material in fluidized bed

Modeling Agglomeration Behavior in High Temperature Gas–Solid Fluidized Beds Via Monte Carlo Method

Limestone Particle Attrition in High-Velocity Air Jets

A Population Model of Quartzite Particles in a Lab-Scale Fluidized Bed Due to the Thermal Fragmentation

Analysis of HZSM‐5 molecular sieve particles attrition behavior under fluidized conditions

Attrition characteristics and mechanisms for limestone particles in an air-jet apparatus

A Volatile Spray Zone Model and Experimentation in a Gas-Solid Fluidized Bed with Liquid Injection

Evolution and Fluidization Behaviors of Wet Agglomerates Based on Formation-Fragmentation Competition Mechanism

Thermal fragmentation of quartzite particles in fluidized bed and gray forecasting model

Attrition Behavior of Fine Particles in a Fluidized Bed with Bimodal Particles: Influence of Particle Density and Size Ratio

Thermal Stress-Induced Fragmentation of Quartzite Particles in a Hot Fluidized Bed

Attrition of CaO-based adsorbent in a laboratory-scale fluidized system

Influence of Coal Ash Components on Attrition Characteristics in Circulating Fluidized Bed

Mechanism of Quartz Bed Particle Layer Formation in Fluidized Bed Combustion of Wood-Derived Fuels

Numerical Simulation of Fluidized Bed Coating Process Considering Particle Abrasion

Attrition of limestone during fluidized bed calcination and sulfation

Modeling Sulfur Retention in Circulating Fluidized Bed——application of Percolation Theory

Attrition Performance and Morphology of Limestone under Different Conditions in Fluidized Bed