Abstract:Attrition of catalyst in a fluidized bed reactor is an inevitable issue especially in a commercial unit. Methanol to olefins (MTO) is becoming one of the main stream technologies for light olefins production. The attrition of MTO catalyst, however, received little attention. This study is focused on the attrition behavior of MTO catalyst in jet cup at high temperature. The influence of test time, inlet gas velocity, and temperature on MTO catalyst attrition was studied. It is found that the Gwyn formulation can well represent the relation between attrition index and test time. Our results show that jet cup can retrieve results quantitatively comparable to high velocity gas jets method while significantly shortening test time. It is also found that the inlet gas velocity has considerable influence on the MTO catalyst attrition, and the relation between inlet gas velocities and attrition index can be described by a power index of 3.7. Similar to high velocity gas jets experiments the attrition index manifests a maximum with the increase of temperature. But the temperature corresponding to the maximum attrition index shifts from 300°C in high velocity jets tests to 100°C in jet cup experiments. An analysis based on SEM pictures indicates that the transition of attrition mechanism is responsible for this shift. An empirical correlation has been presented for MTO catalyst attrition in jet cup, which shows good agreement with experimental data for inlet gas velocity from 88 to 158m/s, and temperature from 100 to 500°C.

Analysis of HZSM‐5 molecular sieve particles attrition behavior under fluidized conditions

Attrition Behavior of Fine Particles in a Fluidized Bed with Bimodal Particles: Influence of Particle Density and Size Ratio

Mathematic Model of Attrition of Quartzite Particles As Medium Material in Fluidized Bed

Advanceson improving the attrition resistance of molecular sieve catalysts for fluidized bed

Limestone Particle Attrition in High-Velocity Air Jets

Modeling Agglomeration Behavior in High Temperature Gas–Solid Fluidized Beds Via Monte Carlo Method

Attrition characteristics and mechanisms for limestone particles in an air-jet apparatus

Evolution and Fluidization Behaviors of Wet Agglomerates Based on Formation-Fragmentation Competition Mechanism

Attrition of CaO-based adsorbent in a laboratory-scale fluidized system

CFD Simulation of an Agitated Gas-Fluidized Bed: Effects of Particle–particle Restitution Coefficient on the Hydrodynamics

Attrition experiment and gray relational analysis of quartzite particles as medium material in fluidized bed

A model on attrition of quartzite particles as a bed material in fluidized beds

Influence of Temperature on Fluidized‐Bed Catalyst Attrition Behavior

Effects of Interparticle Forces on Fluidization Characteristics in Liquid-Containing and High-Temperature Fluidized Beds

Attrition of Activated Carbon Particles in a Coupled Fluidized and Fixed Bed Reactor

Modeling of the Minimum Fluidization Velocity and the Incipient Fluidization Pressure Drop in a Conical Fluidized Bed with Negative Pressure

Numerical Simulation of Fluidized Bed Coating Process Considering Particle Abrasion

Attrition of Methanol to Olefins Catalyst in Jet Cup

Analysis of semi-molten hollow particle spreading and deformation in plasma spraying

Particles attrition of binary mixtures in the coal-fueled chemical looping system based on fluidized bed

Attrition Studies of an Iron Fischer–Tropsch Catalyst Used in a Pilot-Scale Stirred Tank Slurry Reactor