Abstract:Fragmentation experiments of quartzite particles were carried out in a laboratory-scale hot fluidized bed. The influences of the factors, the initial particle size (2.5–6 mm) and the bed temperature (650–950 °C), on the fragmentation were investigated. The experimental results indicate that both the fragmentation ratio (Nf) and the fragmentation index (Sf) curves show a nearly linearly increase with the initial particle size from 2.5 to 6 mm or with the bed temperature from 650 to 950 °C. The changing ratio of size (Fd) is relatively invariant with the initial particle size at all considered bed temperatures except the initial particle size of 5–6 mm at which Fd shows a more intense reduction at a higher bed temperature as a whole. The extent of the fragmentation is quite limited when the bed temperature is lower than 750 °C and the initial particle size is smaller than 3 mm. The analysis of the quartzite particles size distribution after fragmentation shows that it is the compressive and thermally induced stresses within the outer region of the particle that causes the particle to fracture with many small fragments on the particle surface. Finally, based on the grey theory, a grey forecasting model GM(1, 3) is developed to predict the thermal fragmentation of the quartzite particles. The comparison demonstrates that the forecasted values are in good agreement with the experimental data, and the average residual error is lower than 7.13%. Using the model GM(1, 3), the critical fragmentation diameter (dc) under different bed temperatures is forecasted.

A Population Model of Quartzite Particles in a Lab-Scale Fluidized Bed Due to the Thermal Fragmentation

Thermal fragmentation of quartzite particles in fluidized bed and gray forecasting model

Thermal Stress-Induced Fragmentation of Quartzite Particles in a Hot Fluidized Bed

Modeling Agglomeration Behavior in High Temperature Gas–Solid Fluidized Beds Via Monte Carlo Method

Mathematic Model of Attrition of Quartzite Particles As Medium Material in Fluidized Bed

Modeling Axial Distributions of Adsorbent Particle Size and Local Voidage in Expanded Bed

Evolution and Fluidization Behaviors of Wet Agglomerates Based on Formation-Fragmentation Competition Mechanism

A Volatile Spray Zone Model and Experimentation in a Gas-Solid Fluidized Bed with Liquid Injection

A model on attrition of quartzite particles as a bed material in fluidized beds

Experimental and Modeling Investigation of Liquid-Induced Agglomeration in a Gas–Solid Fluidized Bed with Liquid Spray

Research on Separation Mechanism of Liquid-Solid Fluidized Bed Separator

Stable Operating Range and Solids Residence Time of Fine Fluorite Particles in the Two-Stage Fluidized Bed

Attrition experiment and gray relational analysis of quartzite particles as medium material in fluidized bed

97/02177 The research on the fragmentation of coal particles in a fluidized bed

An Experimental Study on the Primary Fragmentation and Attrition of Limestones in a Fluidized Bed

Particle-scale Simulation of Fluidized Bed with Immersed Tubes

Mechanism of Quartz Bed Particle Layer Formation in Fluidized Bed Combustion of Wood-Derived Fuels

Effect of Cohesive Particle Addition on Bubbling Characteristics of Gas-Solid Fluidized Bed: Meso-scale Mechanism

Fragmentation Behavior of the Large Particles during Coal Combustion in Fluidized Bed

New model to evaluate the impact of quartz sand crushing on fracture conductivity in a proppant monolayer

Development of a Coalescence Model in Gas–solid Fluidized Bed for the Population Balance Equation