Abstract:This paper reports the results of thermal spallation experiments on specially dried shale samples with 3 bedding orientations (0°, 45° and 90°) under 3 flame temperatures (899 °C, 1243 °C and 1559 °C) and the 3D thermal elastic finite element modelling. Under open flame heating, continuous spallation is observed with ejection of various spalls and popping sounds. After a period of spallation, tensile fractures are formed in the samples and grow perpendicular to the heating surface, except for a sample with bedding orientation of 90° under the low temperature. Increasing flame temperature promotes ejection, popping sounds and spallation rate, but reduces the spallation starting time, spallation duration, depression diameter and depression depth. The model shows that heating induces compressive stress in the surface layer and tensile stresses beneath it. The tensile stress is found to be sufficient to generate large tensile fractures. The ratio between the induced compressive and tensile stresses increases with increasing spallation depth but little affected by the flame temperature. The spallation compressive stress increases with temperature from 29 to 51% of the uniaxial compressive strength. This stress is shown to be sufficient to cause buckling of thin layers separated from the bulk of the rock. The size of the buckling layer is smaller than the size of the spallation zone leading to a mosaic pattern seen on the surface after spallation. The results are important for further understanding of the mechanism of thermal spallation of rocks as well as large scale spallation-like processes in the Earth's crust.

Thermal fragmentation of quartzite particles in fluidized bed and gray forecasting model

Thermal Stress-Induced Fragmentation of Quartzite Particles in a Hot Fluidized Bed

A Population Model of Quartzite Particles in a Lab-Scale Fluidized Bed Due to the Thermal Fragmentation

Modeling Agglomeration Behavior in High Temperature Gas–Solid Fluidized Beds Via Monte Carlo Method

Evolution and Fluidization Behaviors of Wet Agglomerates Based on Formation-Fragmentation Competition Mechanism

Attrition experiment and gray relational analysis of quartzite particles as medium material in fluidized bed

97/02177 The research on the fragmentation of coal particles in a fluidized bed

Analysis of fragment size and ejection velocity at high strain rate

Mathematic Model of Attrition of Quartzite Particles As Medium Material in Fluidized Bed

Fragmentation Behavior of the Large Particles during Coal Combustion in Fluidized Bed

The Fragmentation of Coal Particles During the Coal Combustion in a Fluidized Bed

Mechanics of thermal spallation and fracturing of dry rocks produced by surface heating

A Survey of the Research Findings Concerning the Thermal Fragmentation Phenomena of Anthracite During its Combustion in a Fluidized Bed

An Experimental Study on the Primary Fragmentation and Attrition of Limestones in a Fluidized Bed

A model on attrition of quartzite particles as a bed material in fluidized beds

Thermal Behavior and Surface Microstructure of Quartzite Particles

Thermal fragmentation and pulverization behavior of lignite during the vibration drying process and its grey relational analysis of multi-factors

Experimental study on primary fragmentation of coals in fluidized bed

Experimental Research On The Fragmentation Of Long-Yan Anthracite With Different Lithotypes In Fluidized Bed Combustion

Experimental Study on Calcination and Fragmentation Characteristics of Limestone in Fluidized Bed

EXPERIMENT AND NEURAL NETWORK MODEL OF PRIMARY FRAGMENTATION OF OIL SHALE IN FLUIDIZED BED