Abstract:The (1 − x)(Li 0.03 Na 0.5 K 0.47 )(Nb 0.92 Sb 0.05 Ta 0.03 )O 3 –xBa 0.85 Ca 0.15 Zr 0.1 Ti 0.9 O 3 (LNKNST–BCZT, x = 0, 0.5, 1.5, 2.5, and 3.5%) lead-free piezoceramics were synthesized by the conventional solid-state reaction method with adding nano-sized Ba 0.85 Ca 0.15 Zr 0.1 Ti 0.9 O 3 (BCZT) powder to investigate their influences on crystal structure and electrical properties. The X-ray diffraction (XRD) analysis reveals that all the sintered LNKNST–BCZT ceramics exhibit pure perovskite structure with the mainly rhombohedral (R) phase or the coexistence of rhombohedral (R) phase and tetragonal (T) phase. The composition of the LNKNST–1.5%BCZT ceramics locates around the critical point, i.e., the ceramics changing from the coexistence of rhombohedral (R) phase and tetragonal (T) phase to purely rhombohedral (R) phase, and presents the most densified microstructure morphology, which can be confirmed further by the field emission scanning electron microscope (FESEM) observation. There are two dielectric anomalies in the temperature dependent dielectric properties curves of the LNKNST–BCZT ceramics, which correlate with the ferroelectric rhombohedral (R) phase changing to the ferroelectric tetragonal (T) phase, and then to the paraelectric cubic (C) phase. Both the Curie–Weiss law and the power law fittings confirm the diffuse phase transition ferroelectrics characteristic of the LNKNST–1.5%BCZT ceramics, which is considered as correlating with the polar nanoregions (PNRs). Due to the densification effect caused by the chosen amount of nano-sized BCZT doping and the construction of R–T polymorphic phase boundary, the LNKNST–1.5%BCZT ceramics exhibit the best ferroelectric and piezoelectric properties. The complex impedance spectroscopy analysis confirms that the extrinsic electrical conduction mechanism at high temperatures is dominated by the oxygen vacancies induced by the evaporation of the alkali metals during sintering.

Fabrication and Electrical Properties of Fine-Scale 1–3 Piezoceramic/Epoxy Composites Using (K,na)nbo3-Based Lead-Free Ceramics

Effects of Na Excess on the Preparation and Characterization of (K0.5na0.5)nbo3ceramics

New K0.48Na0.52NbO3–Bi(Zn0.5Zr0.5)O3 Lead-Free Ceramics: Microstructure and Piezoelectricity

Investigation on Co‐fired Multilayer KNN‐based Lead‐free Piezoceramics

Micro-Fabrication and Properties of Micro-Scale 1-3 Connective Potassium Sodium Niobate-Based Lead Free Piezoelectric Ceramic/Epoxy Composites

Preparation of KNN Based Lead-Free Piezoelectric Ceramics Via Composition Designing and Two-Step Sintering

Electrical Performance and Conduction Mechanism of Potassium Sodium Niobate-Based Lead-Free Piezoceramics Via Two-Step Sintering Route

High Piezoelectric Properties and High TC in KNN-Based Lead-Free Ceramics Sintered in Reducing Atmosphere

High mechanical quality factor and piezoelectricity in potassium sodium niobate ceramics

Effects of nano-sized BCZT on structure and electrical properties of KNN-based lead-free piezoceramics

Sintering and Electrical Properties of Lead-Free Na0.5k0.5nbo3 Piezoelectric Ceramics

Novel 1–3 (K,Na)NbO3-based ceramic/epoxy composites with large thickness-mode electromechanical coupling coefficient and good temperature stability

Dice-and-fill Processing and Characterization of Microscale and High-Aspect-ratio (K, Na)NbO3-based 1–3 Lead-Free Piezoelectric Composites

Comprehensive Investigation of Elastic and Electrical Properties of Li/Ta-modified (k,na)nbo3 Lead-Free Piezoceramics

Effect of Sintering Conditions on the Electrical Properties of Lead-Free Piezoelectric Potassium Sodium Niobate-Based Ceramics

Piezoelectricity of lead-free (K, Na)NbO3 nanoscale single crystals

(K, Na)NbO 3 -based lead-free piezoceramics: Phase transition, sintering and property enhancement

(K,na)nbo3‐based Lead‐Free Piezoceramics: Fundamental Aspects, Processing Technologies, and Remaining Challenges

Sintering properties of K_(0.5)Na_(0.5)NbO_3 lead-free piezoelectric ceramics

The structural origin of enhanced piezoelectric performance and stability in lead free ceramics

Fabrication and Magnetoelectric Effect of 1–3 Type Composites with Microscale (K,na)nbo3-Based Pb-free Piezoceramic Pillars Embedded in CoFe2O4-epoxy Matrix