Abstract:With the development of large span and heavy load modern engineering, concrete-filled steel tubular truss and laced column structures appear constantly. The joints of these structures are mostly circular Concrete-Filled Steel Tubular (CFST) joints. In order to solve the problem of lacking of the research on the mechanical properties of CFST joints, three CFST T-joints and one Circular Hollow Section (CHS) T-joint which was used for comparing were tested under reversed cyclic axial loading, and three CFST T-joints and one CHS T-joint were tested under reversed cyclic in-plane bending loading. The failure modes and the ultimate load carrying capacities of CFST T-joints were concluded and the load-displacement hysteretic curves were also studied. The test results showed that the failure modes of CFST joints and CHS joints with the same geometry were completely different, the ultimate load carrying capacities of CFST joints were much higher than that of CHS joints, which shows that adopting a concrete-filled chord member is the most effective way to improve the strength of the unstiffened tubular joints when subjected to axial loading and in-plane bending, the energy dissipation mechanisms of CFST joints and CHS joints were completely different, but both CFST joints and CHS joints had excellent seismic performances. The energy analysis of CFST joints under differing loading conditions indicated that there was a significant distinction in terms of the energy dissipation mechanism. The axially loaded specimens dissipated energy mainly by plastic deformation of the brace, while the in-plane bending loaded specimens dissipated energy mainly by punching shear of the chord wall at the intersection area. This research can not only provide scientific basis for the design of CFST joints, but also effectively promote the application of CFST truss and laced column, and can promote the improvement and development of the design theory of concrete-filled steel structures.

A PRACTICAL METHOD OF CHECKING THE TUBULAR JOINT STATIC STRENGTH

Ultimate Strength of the Circular Tubular X-joints

Experimental study of the static behavior of tubular N-joints

Simplified theoretical solution and practical calculation method for welded hollow spherical joints of rectangular hollow section members

Load-carrying Capacity and Practical Calculation Method of Welded Hollow Spherical Joints with Square Steel Tubes Subjected to Combined Axial Forces and Biaxial Bending Moments

EXPERIMENTAL RESEARCH AND FINITE ELEMENT ANALYSIS ON A WELDED JOINT WITH TUBES INTERSECTED AT TWO DIFFERENT POINTS

RESEARCH ON THE BREAKAGE MODE AND ANALYTIC MODEL OF CIRCULAR TUBULAR X-JOINTS

Study on In-Plane Behavior of Thin-walled Concrete-filled Steel Tubular Gusset Plate T-joints

Experimental study and FEM analysis on mechanical behavior of a steel tubular joint with bolted connection subject to biaxial compression

Non-linear Analysis on Cast Tubular T-joint Loaded by In-Plane Bending

Nonlinear Analysis for the Bearing Properties of Multiplanar Tubular Joints with Square and Circular Hollow Sections

Reinforcement design and analysis of tubular joints

NUMERICAL STUDY OF STAINLESS STEEL CIRCULAR HOLLOW SECTION TUBULAR JOINTS

Compressive Tests of Thin-Walled Circle Concrete-Filled Steel Tubes

Experimental Investigation And Design Of Concrete-Filled Cold-Formed Thin-Walled Steel Tubes Subject To Bending

Design Of Concrete-Filled Steel Tubular Chs Connections In Tension

Study Of Mechanical Performance Of Concrete-Filled Steel Tubular Joints

Non-linear Analysis on Axially Loaded Cast Tubular T-joints Including the Effects of Fillet Parameter

Nonlinear Analysis on Ultimate Flexural Bearing Capacity of the N-Shaped Steel Tubular Joints

Nonlinear Finite Element Analysis of Ultimate Strength on Tubular K-Joints:Square Chords and Circular Braces

Non-Linear Analysis of Ultimate Loading Capacity of Cast Tubular Y-Joints under Axial Loading