Abstract:Abstract This paper discusses the effect of hydrolytic pretreatments on pulp dissolution in the aqueous NaOH–ZnO solvent system. Eight samples were studied. They consisted of a never-dried softwood kraft pulp that was hydrolyzed under seven different conditions as well as the pulp without hydrolysis as a reference. The dissolution of the pulps was evaluated both at the macro level as well as at the molecular level based on their reactivity with 4-acetamido-2,2,6,6-tetramethylpiperidine-1-oxo-piperidium (4-AcNH-TEMPO + ). The fiber properties (i.e. the extent of fibrillation, amount of fines and fiber width, coarseness, and length) as well as the chemical composition (hemicellulose and cellulose contents) and the viscosity of the pulps was investigated. The results show that hydrolysis at medium consistency (10%) was successful in increasing the solubility of cellulose. Hydrolysis at high consistency (50%), on the other hand, increased the solubility only to some extent. With extended treatment time the fibers formed aggregates and their dissolution became poor. This phenomenon could be overcome by mechanically refining the fibers after the hydrolysis. Moreover, comparison of the viscosity of the pulp over the degree of oxidation revealed that the viscosity needed to decrease below ca. 400 ml/g in order for the outer layers of the fibers to dissolve. Finally, when pulps with similar viscosities where compared against each other, the ones with the higher glucomannan contents formed gels over time. This was true also for the pulp with the lowest viscosity and the highest solubility of the studied samples.

Role of Sodium Zincate on Cellulose Dissolution in NaOH/urea Aqueous Solution at Low Temperature

Cellulose dissolution in aqueous NaOH–ZnO: cellulose reactivity and the role of ZnO

Effects of additives on dissolution of cellobiose in aqueous solvents

Study of Cellulose Dissolution in ZnO/NaOH/Water Solvent Solution and Its Temperature-Dependent Effect Using Molecular Dynamics Simulation

Dissolution of cellulose in aqueous NaOH/urea solution: role of urea

Effects of Temperature and Molecular Weight on Dissolution of Cellulose in NaOH/urea Aqueous Solution

The Kinetics Of Cellulose Dissolution In Sodium Hydroxide Solution At Low Temperatures

Solubility of Cellulose in NaOH/Urea Aqueous Solution

MICRO-CELLULOSE PREPARATION METHOD BASED ON UREA/NaOH DISSOLVED SYSTEM

Effect of hemicellulose content on the solution properties of cellulose carbamates in NaOH/ZnO aqueous system

Dissolution Of Cellulose In Zncl2 Aqueous Solution

Participation of sodium sulfamate as hydrogen bond-donating and hydrogen bond-accepting additive in the dissolution of cellulose in NaOH aqueous solution

The Dissolution of Cellulose in NaOH-based Aqueous System by Two-Step Process

The thermodynamics study on the dissolution mechanism of cellobiose in NaOH/urea aqueous solution

Cellulose dissolution in aqueous NaOH–ZnO: effect of pulp pretreatment at macro and molecular levels

Novel insights on room temperature-induced cellulose dissolution mechanism via ZnCl2 aqueous solution: Migration, penetration, interaction, and dispersion

The Thermodynamics of Enhanced Dope Stability of Cellulose Solution in NaOH Solution by Urea.

Dissolution of cellulose from different sources in an NaOH/urea aqueous system at low temperature

TEMPO-Mediated Oxidation Promotes Cellulose Dissolution in a Zincate–NaOH System at Suprazero Temperatures

Role of urea in alkaline dissolution of cellulose

Preparation of ZnO–cellulose nanocomposites by different cellulose solution systems with a colloid mill