Abstract:To address the sharp decrease in efficiency of the biological activated carbon (BAC) process at low temperatures, a new type of activated carbon (AC), macroporous activated carbon (MAC), was developed from bamboowaste scraps via a special compression, carbonation and activation process without the introduction of chemicals. MAC contains not only the micron-level macropores (V-maco > 0.71 ml/g) sufficient for bacteria to access and multiply, but ensures the developed smaller pores (particularly micropores, V-micro > 0.41 ml/g) and a higher hardness (>90%). In addition, the desired volume of macropores with an adiabatic function, which will provide livable space environment for bacteria, can be obtained by adjusting the compression ratio (1: 5-1: 10). Because of the maximum macropore volume (V-maco = 0.805 ml/g) and the most abundant macropore distribution (particularly diameters>10,000 nm), MAC (1: 6) was selected for the parallel experiment in the laboratory, taking three representative commercial ACs (PICABIOL (R) 2, raw coal AC-1 and briquetting AC-2) as controls, in which the filtration effluent of a water treatment plant was used as the influent and glucose was added to accelerate bacterial growth. The results showed that MAC (1: 6) exhibited the highest DOC removal and biological activity at room/low temperatures (4 degrees C), indicating that the abundant macropores distribution with adiabatic function in MAC (1: 6) is conducive to the growth and breeding of microorganisms. It is equivalent to artificially increasing the surface suitable for bacteria attachment. This is coupled with the higher adsorption capacity for pollutants supplied by the developed micropores in MAC, which provided the substrate for bacteria growth, thus forming a benign circle for water treatment by the BAC process. The results provide significant technical support for BAC's application, particularly at cold temperatures. (c) 2018 Elsevier B.V. All rights reserved.

Study on Effect of Temperature on Biological Activated Carbon Process

Removal Efficiency of Combined Treatment Process on Raw Water with High Ammonia Nitrogen and High Organic Pollutants

Immobilized Biological Activated Carbon Process for Enhancing the Advanced Drinking Water Treatment

Comparison of O3 - BAC Combination and Conventional Processes on Removal of Pollutants for Treating Drinking Water

Changes of Biomass and Bacterial Communities in Biological Activated Carbon Filters for Drinking Water Treatment

Influence of ozone/ceramic membrane on performance and microbial community in biological activated carbon filtration

Preparation, Characterization, and Application of Macroporous Activated Carbon (MAC) Suitable for the BAC Water Treatment Process

Effects of water temperature and backwashing on bacterial population and community in a biological activated carbon process at a water treatment plant

A comparative study of upflow/downflow biological activated carbon technics effect in drinking water advanced treatment

Investigation of Microbial Safety of A Full-Scale Ozonation and Biological Activated Carbon Process under High Humidity and Temperature Conditions

Effect of Aged Biological Activated Carbon on the Filtration Resistance and Performance of Biological Activated Carbon Filter

Effects of temperature and dissolved oxygen on biological activated carbon treating drainage from steel and iron industry

Pretreatment of Light-polluted Raw Water by Biological Active Carbon Expended Bed

Influence of Temperature on Treating Nitrification of High Ammonia Nitrogen Source Water in Biological Carbon Filter

Effects of low frequency ultrasound treatment on dissolved organic nitrogen removal by biological activated carbon: Critical insights into molecular characteristics, microbial traits, and metabolism

Effects and Mechanisms of Ozone/Biological Activated Carbon Process for Advanced Treatment of Industrial Park Wastewater

Characterization of DOM and disinfection by-products precursors in biological activated carbon filter backwash water from drinking water treatments

Physicochemical and porosity characteristics of thermally regenerated activated carbon polluted with biological activated carbon process.

Study on Ecological Characteristics of Microorganisms in Biological Activated Carbon Filter

Study on reactivation cycle of biological activated carbon (BAC) in water treatment

A new process to further remove dissolved organic matter and disinfection by-product formation potential during drinking water treatment