Abstract:Solid concentration and particle velocity distributions in the transition section of a ϕ 200mm turbulent fluidized bed (TFB) and a ϕ 200mm annulus turbulent fluidized bed (A-TFB) with a ϕ 50mm central standpipe were measured using a PV6D optical probe. It is concluded that in turbulent regime, the axial distribution of solid concentration in A-TFB was similar to that in TFB, but the former had a shorter transition section. The axial solid concentration distribution, probability density, and power spectral distributions revealed that the standpipe hindered the turbulence of gas–solid two-phase flow at a low superficial gas velocity. Consequently, the bottom flow of A-TFB approached the bubbling fluidization pattern. By contrast, the standpipe facilitated the turbulence at a high superficial gas velocity, thus making the bottom flow of A-TFB approach the fast fluidization pattern. Both the particle velocity and solid concentration distribution presented a unimodal distribution in A-TFB and TFB. However, the standpipe at a high gas velocity and in the transition or dilute phase section significantly affected the radial distribution of flow parameters, presenting a bimodal distribution with particle concentration higher near the internal and external walls and in downward flow. Conversely, particle concentration in the middle annulus area was lower, and particles flowed upward. This result indicated that the standpipe destroyed the core-annular structure of TFB in the transition and dilute phase sections at a high gas velocity and also improved the particle distribution of TFB. In conclusion, the standpipe improved the fluidization quality and flow homogeneity at high gas velocity and in the transition or dilute phase section, but caused opposite phenomena at low gas velocity and in the dense-phase section.

Experimental Study on Gas-Holdup and Gas-Liquid Interfacial Area in Tpcfbs

Solid Concentration and Velocity Distributions in an Annulus Turbulent Fluidized Bed

Experimental and numerical investigation of solid behavior in a gas–solid turbulent fluidized bed

Experimental and Numerical Study of Solids Concentration Distribution in Transition Section of Turbulent Fluidized Bed

Particle Velocity Measurements in Transition Section of Turbulent Fluidized Beds Using Optical Fiber Probe and CFD Simulation

Experimental Study on the Bubble Rise Velocity in Three-Phase Circulating Fluidized Beds

Experimental study on bubble behavior in gas–liquid–solid three-phase circulating fluidized beds

Mass Transfer Characterization for Hydrocarbon Liquid–particle Collision Based on Sensitive Tracing of Fluorescent Probe

Multi-scale Characteristics and Gas-Solid Interaction among Multiple Beds in a Dual Circulating Fluidized Bed Reactor System

CFD Simulation and Experiments of Dynamic Parameters in Gas–solid Fluidized Bed

Dynamic and Steady-State Characterization of the Liquid Spray Zone in an Externally Heated Gas–Solid Fluidized Bed

Experimental Measurement and Theoretical Analysis on Bubble Dynamic Behaviors in a Gas-Liquid Bubble Column

Experimental Investigation of Bubble and Particle Motion Behaviors in A Gas-Solid Fluidized Bed with Side Wall Liquid Spray

Effects of Interparticle Forces on Fluidization Characteristics in Liquid-Containing and High-Temperature Fluidized Beds

Experimental study on gas–liquid interfacial area and mass transfer coefficient in three-phase circulating fluidized beds

Experimental Research on the Gas-Solid Flow Characteristics in Large-Scale Dual Fluidized Bed Reactor

Revealing instantaneous gas-particle segregation in bubbling and turbulent fluidized beds through fiber optic sensing

Gas-Liquid Interfacial Area and Mass Transfer Coefficient in a Three-phase Circulating Fluidized Bed

Experimental Investigation on Local Particle Volume Fractions Distribution in Offset-Exit Circulating Fluidized Bed

[Gas-Liquid Mass Transfer in Three-Phase Inverse Turbulent Bed Reactor].

A Numerical Study on Gas-Fluidized Beds of Wet Flexible Fibers