The mechanical properties of the macro-interface in squeeze cast SiCw/AZ91 magnesium matrix composites

Mingyi Zheng,Kun Wu,Subo Li,Congkai Yao

DOI: https://doi.org/10.1023/A:1017978514050

2001-01-01

Journal of Materials Science Letters

Abstract:Squeeze casting is one of the most cost-effective methods of fabricating discontinuously reinforced metal matrix composites. One of the advantages of squeeze casting over other fabrication methods of composites, such as powder metallurgy, stir casting, etc, lies in its possibility to fabricate selectively reinforced composites, such as selectively reinforced squeeze cast pistons [1], which is low cost, lightweight and durable. In a selectively reinforced metal matrix composite, the preform is normally only used to strengthen a portion of the casting, and the rest casting is not reinforced. Then, a boundary is introduced between the composite and the matrix zones, which is commonly called the macrointerface [2, 3]. As with the interface between the matrix and the reinforcement in the composite, there also exists discontinuity of mechanical and physical properties at the interface between the matrix zone and the composite zone. Most studies in the field of squeeze cast metal matrix composites have been carried out on the region of the casting containing the preform, very few investigations have been focused on the macrointerface between the matrix zone and the composite zone [2‐5].