Abstract:TiO2-diatomite photocatalysts were prepared by sol-gel process with various pre-modified diatomite. In order to obtain diatomite with different surface characteristics, two modification approaches including calcination and phosphoric acid treatment on the micro-structure of diatomite are introduced. The photocatalysts were characterized by XRD, XPS, nitrogen adsorption-desorption isotherms and micromorphology analysis. The results indicate that, compared with pure TiO2, the anatase-to-rutile phase transition temperature of TiO2 loaded on diatomite carrier is significantly increased to nearly 900 degrees C, depending on the different pretreatment method of diatomite. The photocatalytic activities of different samples were evaluated by their degradation rate of methyl orange ( MO) dye under UV and visible-light irradiation. The samples prepared by phosphoric acid pretreatment method exhibit the highest photocatalytic activity. After 90 min of UV irradiation, about 90% of MO is decomposed by the best effective photocatalyst. And after 8 h visible-light irradiation, nearly 60% of MO is decomposed by the same sample. Further mechanism investigation reveals that the H3PO4 pretreatment process can obviously change the surface features of diatomite carrier, cause the formation of Si-O-Ti bond, increase the binding strength between TiO2 and diatomite, restrain crystal growth of loaded TiO2, and thus form thermal-stable meso-porous structure at the granular spaces. It helps to build micro-, meso- and macro-porous hierarchical porous structure in TiO2-diatomite, and improves the charge and mass transfer efficiency during catalyzing process, resulting in the significantly increased photocatalytic activity of TiO2-diatomite pretreated by phosphoric acid. (C) 2014 Elsevier B. V. All rights reserved.

EFFECT OF TETRAETHYL ORTHOSILICATE ON PREPARTION AND PROPERTIES OF POROUS ANATASE TITANIA FILM AT ROOM TEMPERATURE

Influence of Factors on Porous TiO_2 Films Prepared at Room Temperature

INFLUENCE OF WATER CONTENT ON CONTENT AND CHARACTERISTIC OF TiO2 DURING PREPARATION OF TiO2 NANOPARTICLES ON SiO2 SURFACE

Study on in-situ Modification of Vinyl Acetate-Acrylate Latex by Anatase TiO2 Sol

Room-temperature preparation and formation mechanism of porous anatase TiO2 film

Low-Temperature Preparation of Ag-TiO2 Composite Films and Their Properties

Room-Temperature Preparation of TiO2-SiO2 Composite Film and Its Properties

Preparation of Macroporous and Mesoporous Tio2 Film with Various Solvents

The Effects of Substrate on the Properties of Sol-Gel Derived TiO2 Films

Investigation on the Microstructure and Optical Performance of TiO_2 Films by Sol-Gel Method

A Preparation Method To Obtain Porous Anatase Tio2 Films At Room Temperature

Controllable Fabrication and Characterization of Porous C/TiO2 Nanocomposite Films As Solar Selective Absorber

Effects of HPC on the Microstructure and Hydrophilicity of Sol–gel-Derived TiO2 Films

Porous titania films prepared from interactions of titanium with hydrogen peroxide solution

PREPARATION OF IRON-DOPED TITANIA NANOCRYSTALLINE GRAINS AND ITS PHOTOCATALYTIC PROPERTY

Fabrication of Porous Tio2 Film Via Hydrothermal Method and Its Photocatalytic Performances

The Effects of PEG on the Microstructure and Dye Adsorption of TiO2 Films

Structure and Photocatalytic Properties of TiO2/Perfluorosulfonated Resin Hybrid Films Prepared by Sol-Gel Method

Low-Temperature Preparation of Macroporous Anatase TiO2 Thin Film and Its Photocatalytic Activity

Preparation and characterization of porous carbon–titania nanocomposite films as solar selective absorbers

Interface Actions Between TiO2 and Porous Diatomite on the Structure and Photocatalytic Activity of TiO2-diatomite